十分经典的开源反编译工具，基本上是所有开源反编译工具中最好的一个...

是一个G代码转换的源程序，将标准G代码读入后在UG环境下生成加工代码刀具路径。-G is a conversion of source code, to reduce the standard G code read in the UG environment processing code generated tool paths.

红外遥控控制步进电机源代码，对步进电机开发也许有些帮助-Infrared remote control of stepper motor source code, the development of the stepper motor may be of some assistance

HT24 系列的EEPROM 总共8 个管脚，三个为芯片地址脚A0、A1、A2，在单片机对它进行操作时，从SDA 输入A0、A1、A2 数据和芯片外部A0、A1、A2 所接地址需一一对应。一个为芯片写保护脚WP，WP 脚接低电平时，芯片可进行读写操作；WP 脚接高时，芯片只可进行读，不可进行写。 另外两个管脚为电源脚VCC，VSS。 用单片机对HT24 系列的EEPROM 进行控制时，HT24 系列的EEPROM 的外部管脚VCC、VSS、WP、A0、A1、A2 根据需要，对应接上，SDA、SCL 接到单片机控制脚上。-HT24 Series EEPROM total of 8 pins, three pins for the chip address A0, A1, A2, in the microcontroller to operate it, from SDA input A0, A1, A2, and chip external data A0, A1, A2 of the Then one correspondence address must be in. One for the chip, write-protect pin WP, WP feet then low, the chip can be read and write operations WP pin is high then, the chip can only be read, not write. The other two pins for the power pin VCC, VSS. With the microcontroller on the HT24 Series EEPROM control when, HT24 Series EEPROM external pin VCC, VSS, WP, A0, A1, A2 according to the needs of the corresponding connected, SDA, SCL receives SCM control feet .

串口通讯经典使用程序4,以前收集整理的东东,希望对大家有用!-Serial Communication Classic to use the program 4, previously collected Dongdong finishing the hope for all of us!

Atmel Uart C51程序（timer1方式）-Uart (timer1 way)

该程序模块包含无线收发模块 NREF905的所有功能库函数 本库函数与外部函数接口简单易用且代码规范简洁-The program module contains the wireless transceiver module NREF905 all the features of library functions of the library function and the external function interface is simple and concise code norms

PIC单片机模拟SPI口-PIC simulation SPI mouth

cd4094驱动程序，驱动1位共阴极数码管，pic12c508a作为控制器，gp0-gp2分别为data,clk,strobe.-cd4094 drivers, driving a total digital cathode tubes, pic12c508a as controller, gp0-Day for data, clk, strobe.

基于Mc9s12dg128b中断方式完成A/D转换的c源

使用FREESCALE单片机内部的EEPROM的程序，经本人试过，完全没有问题，不过使用之前，要先修改内存映射。-Using Freescale