sja1000与串口通信的程序，用串口通信助手可观察结果

基于DS1302的数码管时钟电路设计源程序,使用C51语言编写，可以用于MCS8051单片机-based on the DS1302 digital clock control circuit design source, the use of C51 language, which can be used Mcs8051 MCU

STC12C5410AD+128*64LCD（串行接口）AD转换+液晶显示程序-STC12C5410AD+128* 64LCD (serial interface) AD converter+ LCD program

93C46/66的读写程序，编译环境Uvision2，4线SPI接口的EEprom芯片的读写-93C46/66 literacy program, compile environment Uvision2, 4-wire SPI interface EEprom chip reader

单片机系统用c语言编写关于两个PIC之间的通信的设计。。。本程序采用的单片机型号为PIC16F8- Single-SCM systems c language on the communication between two PIC design. . . This procedure used for the PIC16F877 microcontroller model

触摸屏的校正程序。可以用于触摸屏的校正。在三星的平台上测试通过-Touch screen calibration procedure. Can be used for touch-screen calibration. Samsung

利用单片机加控制直流电机，利用P1口，编制程序输出一串脉冲，经放大后驱动小电机，改变输出脉冲的电平及持续时间，达到使电机正转、反转、加速、减速。停转之目的。 可以通过74LS244输入开关量数据来控制小直流电机的转动，实现正转四种转速，反转四种转速及停转。 -The use of SCM in controlling the DC motor

一个凌阳单片机多中断源的实际例子,很具有代表意义,值得研究哦-Sunplus more than a single-chip interrupt sources of practical examples, it is with the representative of significance, worthy of study Oh

72段LCD驱动器SD0418的测试程序-72 LCD drive SD0418 test procedures

初学单片机,第一个程序,主要是控制8位LED数码灯以单双位交替闪烁.-Beginner MCU, the first program, mainly for controlling the 8-bit LED digital light flashing alternately to odd and even bits.

51单片机与USB芯片PDIUSBD12接口固件程序,来源于周立功单片机-51 MCU with USB interface chip PDIUSBD12 firmware procedures, Zhou, who comes from SCM