由MSP430和CC1100+构成的无线传感器

利用点阵显示显示中文字符，为PIC单片机控制--Display Chinese characters using lattice. It is controled by PIC SCM.

次程序为05全国电子设计大赛《悬挂系统》的源程序，供大家参考一下。-Meeting procedures for the 05 National Electronic Design Competition

单片机中的EEPROM模块，在CVAVR中已实现。-Single-chip EEPROM in the module, in CVAVR already realize.

义隆单片机读写24C** ** 24CXX 接口I2C总线读/写的程序 ** （所有时序均基于4MHZ晶体震荡器频率）-Elan Single-chip 24C**** 24CXX read and write I2C bus interface read/write procedures** (All timing are based on the frequency of 4MHz crystal oscillator)

单片机智能抢答器设计论文，以及设计硬件图和附录-Single-chip intelligent design thesis Answer，And design the hardware chart and Appendix

程序描述:红外遥控RC5码解码程序,经串口发送 目标cpu:lpc932 晶振:11.0592M 硬件描述:一体化接收头接P20.指示LED接P26 编译器:KEIL 7.05 作者:刘玉宏(liu1234)-Description: RC5 infrared remote control code decoding process, by the serial port to send the target cpu: lpc932 crystal: 11.0592M Hardware Description: integrated access to receive the first P20. Instructions LED then P26 compiler: KEIL 7.05 Author:刘玉宏(liu1234)

信号滤波，使用在AVR. 串口接收数据格式 0xFFFF+数据位。-Signal filtering, the use of the AVR. Serial receive data format 0xFFFF+ Data bit.

利用Verilig编写CPLD读写EEPROM（74LC21）程序-Verilig prepared to use CPLD to read and write EEPROM (74LC21) procedures

//115.2k串行口通信程序，校验方式为简单双向校验, //而且是必要的，因为任何采用中断、crc等的方法 //均很难保证速度和避免错误. //总体速度5KB/秒 //单片机程序 //使用22.1184晶振-//115.2k serial port communication procedures and testing methods for the simple two-way check,// it is necessary, because any interruption used, the method crc// it is very difficult to ensure speed and avoid mistakes.// Overall speed 5KB/s// MCU procedures// crystal use 22.1184

这个是完红外线PT2261的源码，绝对的好用，不要改动。是的中断做的阿-This is the End of the PT2261 infrared source, the absolute ease of use, do not change. To do is interrupt the Arab-Israeli