凌阳IDE中写的一个交通灯控制程序，改一下自己的IO代码 直接编译就可以使用了...

这是单片机程序，需要一个GSM模块，用单片机控制GSM模块收发短信。-This is the SCM process, which takes a GSM module, using SCM control GSM transceiver module SMS.

BTF330实验程序。针对c8051f330的大部分外设的实验程序-BTF330 experimental procedures. C8051F330 peripherals for most of the experimental procedures

AT91SAM9260 ARM9设计的网络收音机原理图与代码-AT91SAM9260 ARM9 Radio network design schematics and code

16位元led等电流驱动器mbi5024驱动，-Led, such as 16-bit current driver mbi5024 drive,

51单片机直接驱动液晶显示，里面有两个程序！-51 Single-chip Direct Drive Liquid Crystal Display, which has two procedures!

* 功能：使用PWM6输出PWM信号，通过滤波电实现DAC转换。由KEY1控制PWM的占空比， * 每按一次按键将会改变一次PWM的占空比。 * 说明：使用示波器观察测试点PWM和PWMDAC。-* Function: Use PWM6 output PWM signal, by filtering electrical realize DAC conversion. Key1 controlled by the PWM duty cycle,* every time a button will change the PWM duty cycle.* Note: Use the oscilloscope to observe test points PWM and PWMDAC.

a flight control description with mikrocontroler and DC motors

AD592温度传感器在Atmega8L下的测量程序-AD592 temperature sensor in the measurement procedure Atmega8L

对看门狗5045的操作不是我编的,但我用过,挺好用的..c-right watchdog 5045 is not the operation of Part I, but I used that very well, the c ..

多个C51的源代码,在KEIL C51上已调试通过-number C51 source code, the C51 has KEIL through debugging