AD592温度传感器在Atmega8L下的测量程序

keilC51编写的，配合单片机AT89C51的液晶模块PG12864的驱动显示程序！-keilC51 prepared with AT89C51 single-chip LCD driver module PG12864 display program!

一个单片机实验的电子琴程序清单 用汇编语言编成-a microcontroller experimental procedure, the flower inventory into assembly language

本文给出了一种以80C31为主控CPU的固定电话短信息终端的设计，从系统软硬件两个方面说明了固定电话短信息终端的设计方法和各个部分的工作原理 -This paper proposes a 80C31 CPU for controlling the fixed telephone short message terminal design, system software and hardware from the two showed that the fixed telephone short message terminal design methods and various parts of the work principle

这是点阵程序 个人认为先学点阵再学lcd比较好 p0 p2分别接16*16点阵的高八位和低八位(纵向取模) p3口低四位接4-16线译码器（74ls154）译码器低电平为列选 消除鬼影的方法：-This is the program individual lattice lattice before you think lcd is better to learn p0 p2, respectively, then 16* 16 lattice of high and low 8 8 (vertical modulus) p3 I received a low four 4-16 Line Decoder browser (74ls154) low-level decoder for the elimination of ghosting out the election approaches:

8051c 的一个Crc 算法分析-8051c of an algorithm analysis Crc

采用sja1000开发can总线的源代码-USE SJA1000 DESIGN CAN-BUS SOURCE PROGRAM

单片机c语言开发实例 包括很多实例，希望能在这里找到有用的东西！-SCM c language examples include many examples here in the hope of finding useful things!

RF24L01驱动程序---C51-RF24L01 driver--- C51

三路红外线探头控制ISD2560语音播放。主要原理是正常情况下三对红外线接收管接收到各自配套对应的红外发射管的红外线，属于正常检测状态，一旦有一路红外管信号被隔断，侧启动语音芯片程序，播报警示提醒语音或报警。三对红外管可以根据使用需要，设置搭配报警程序。可用于各种排队系统。-three-way infrared probe control ISD2560 voice broadcast. The main principle is that under normal circumstances receive three pairs of infrared receiver to control their own matching the corresponding infrared emission of infra-red and is a normal state of detection, if there is way infrared control signals are cut off, side launched procedures voice chip, broadcast a warning to remind voice or alarm. Three pairs of infrared tube can be used, the police procedures set match. For various queuing system.

使用键盘上的上、下、左、右四个按键，可以分别控制led1,2,3,4, 每个LED 对应的Port 请参考“实验平台介绍”说明文档。要求按下 上面提到的四个按键中间的一个按键后，该按键对应的led 被点亮，持续1 秒钟以后led 熄 灭。-Use the keyboard on the upper and lower, left, and right buttons, can control led1, 2,3,4, each LED corresponding to the Port, please refer to " experiment on" documentation. Requirements of the four above-mentioned press the middle button of a button, the button that corresponds to being light led, continuous 1 second later led out.