通过USB接口利用多媒体进行数据采集的源程序，通过调试的。...

SPcomm控件源代码,delphi写的!! 有兴趣的可以研究一下!-SPcomm control source code, delphi write! ! Interested parties can see!

通用异步收发器st2552的驱动程序，对于运用UART通信来讲具有通用性。-Universal Asynchronous Receiver Transmitter st2552 driver for use UART communication with the terms of versatility.

pascal写的一个通讯例子 -The communication example writed by pascal

这是我自己写的,请各位高手看一下!!是关于串口方面的编程,用java-This is what I wrote it myself, please look at the top! ! Serial on the program, using java

This program writes a lcd HyperTerminal and everything you type on your keyboard to pc, using codevisionavr.

一个关于Com端口调制的程序。包括向Com端口发送数据及从Com端口接受数据两部分。-a Com port on the modulation process. Including Com port and send data from the Com port to accept data in two parts.

ATMEL的at91rm9200开发板的U-Boot文档-ATMEL at91rm9200 development board of the U-Boot Documents

串行口是计算机一种常用的接口，具有连接线少，通讯简单，得到广泛的使用。常用的串口是RS-232-C接口(又称EIA RS-232-C)它是在1970年由美国电子工业协会(EIA)联合贝尔系统、调制解调器厂家及计算机终端生产厂家共同制定的用于串行通讯的标准。它的全名是"数据终端设备(DTE)和数据通讯设备(DCE)之间串行二进制数据交换接口技术标准"该标准规定采用一个25个脚的DB25连接器，对连接器的每个引脚的信号内容加以规定，还对各种信号的电平加以规定。传输距离在码元畸变小于4%的情况下，传输电缆长度应为50英尺。 　　Linux操作系统从一开始就对串行口提供了很好的支持，本文就Linux下的串行口通讯编程进行简单的介绍.-computer serial port is a common interface, with connecting lines, simple communications, to be widely used. It is commonly used serial RS-232-C interface (also known as the EIA RS-232-C) it is in 1970 by the American Electronics Industry Association (EIA) Joint Bell System, a modem manufacturers and computer terminal manufacturers developed for serial communication standards. Its full title is "data terminal equipment (DTE) and data communications equipment (DCE) between serial binary data exchange interface technology standards," the use of a standard 25 feet to the DB25 connector, the connector pin of each signal content requirements, but also the right signal--

通过串口监测TDRAM是否正常工作的程序。-through serial monitoring TDRAM normal working procedures.

本程序能从键盘读入二个五位十进制数（1位符号位+4位数值位），并将这二个十进制数 分别转换为二进制数，然后求其和，再将和以十进制形式进行显示。-this program from the keyboard read into two five decimal number (1- 4 Symbol numerical), This will be two decimal number were converted to a binary number, and then seek his, and then to decimal form shows.