在LPC2106实现的中断函数和demo,本例程仅对初学这有用

用kirl c51编写的串口通讯程序，该程序可以在编辑器上显示串口数据 -kirl decoder prepared with the serial communication program, which can be displayed on the editor serial data

A very usefull aplication for developers that creates a virtual serial ports for debug purposesin order to see the data out or in.

在ADI公司的blackfin533开发平台上实现串口通信的程序代码-In the ADI" s blackfin533 development platform to achieve serial communication program code

实现图像控制,云台解码器控制,站点选择(配有Access数据库).-image control, pan and tilt control decoder, site selection (equipped with the Access database).

中国海军军事化管理系统,全方位，立体化管理中国海军-this is very good Code Scource.

uart transmitter logic

本程序是i2c总线读写一个字节的程序。在写过程序中，不一定非要检测i2c的应答位，可以直接延时过去就行，但是在读过程中必须给应答信号，读完发停止位，一定确认所发的信号都发上了。否则在连续地址读的过程中可能不会出错，但是在随机度过程中就会出错，我的程序就是在给停止信号时没有给上，24cxx一直在输出数据，结果读出错。找着问题后我的程序只加入了一条命令便完全正常。-i2c bus read and write a byte procedures. The written procedure, not necessarily require the detection i2c-response, and can directly past trip delay, but the process must be read to the response signal, stopped at reading, we recognize the signals are on the fat. Otherwise, the address read for the course could not go wrong, but the randomness of the process would be a mistake, I was in the process to stop for no signal, 24cxx in output data, read errors. I discovered the problem after the procedure just joined the order of a completely normal.

OV7660 YUV源代码，已经验证不会有问题-OV7660 YUV source code, has no problem to verify

使用TC3.0开发的串口通讯程序，在一台电脑上模拟。（本机发到串口，本机再从串口读入）-TC3.0 development of the use of serial communication program, in a computer simulation. (This machine made to the serial port, the company was again read from the serial port)

ms-com uart tools