S3C2440 touchlcd编译例子广告模式作出决定

ARM9_s3c2410的启动代码，绝对是最简单的。有注释，可读性强，适合刚接触嵌入式的新人。-ARM9_s3c2410 the startup code, it is the simplest. Have comments, readable, and suitable for the new刚接触embedded.

嵌入式系统，pda的原码，整个driver部分，arm7 cpu，可以学习arm上的driver 编成-embedded systems, pda"s original code, the entire driver, ARM7 CPU, we can learn from arm into the driver

JTAG的驱动程序，一般都是用在相对应的嵌入式ARM处理器上，这个事实用在LPC2210上面。-JTAG drivers are generally used in relation to the embedded ARM processor, with the fact that the LPC2210 above.

基于说stm32f4的can总线，将实现如下功能：本实验串口1将不停的打印信息到电脑上，同时接收从串口发过来的数据，把发送过来的数据直接送回给电脑。

VMM 文档加源码, synopsys公司很好的验证资料-VMM Document Canadian source, synopsys good company to verify the information

This example program shows how to configure and use the A/D Converter of the following microcontrollers: * Philips LPC 2114/2119/2124/2129/2131/2132/2138/2194 After configuring the A/D Converter, the program reads A/D channel 0 and outputs the converted value using the serial port. To run this program... 1. Select the Device (Project - Options for Target - Device) 2. Build the project (Project - Build Target) 3. Start the uVision Debugger 4. Open the Serial Window (View - Serial Window 1) 5. Click Run (F5) 6. Click on the Toolbox buttons to change input voltages A debug script (debug.ini) creates buttons that set different analog values in A/D channels. As the program runs, you will see the A/D input and output change. Other buttons create signals that generate sine wave or sawtooth patterns as analog inputs. µ Vision3 users may enable the built-in Logic Analyzer to view, measure and compare these input signals grap

S3C44B0X芯片引导程序，简单易懂，TFTP下载并使用ads运行。

44b0芯片的实验配置手册 experiment_handbook_for44b0-Experimental chip 44b0 manual configuration experiment_handbook_for44b0

嵌入式系统ARM论文-papers ARM Embedded System

这个项目是在 Keil 写的。 ARM 处理器 STM32F417 使用的库 STM32F4xx_StdPeriph_Driver。 I2c 总线的软件实现。