128

CCS环境下，二相编码脉冲压缩雷达算法研究（包含整个项目）-CCS environment, the two-phase coded pulse compression radar algorithm (including the entire project)

算术运算在我们普通的计算机上很容易实现！但是在我们的DSP上，由于其没有相对应的程序支持，实现就比较麻烦！那么究竟该怎么做呢！就看看吧！-The arithmetic operation is very easy on our ordinary computer to realize! But on ours DSP, because it has not corresponded the procedure support, the realization quite is troublesome! Actually then should how do! Has a look!

DSP2812下,C调汇编的128点FFT程序,算法为TI提供,定点,测量信号频率和幅度较好,速度比C快三倍左右.-DSP2812 under, C tune compiled 128 points FFT procedures, algorithms for TI to provide, point, measure the signal frequency and amplitude is better, faster than C for about three times faster.

基于DSP2812的spwm程序 EVA下面的通用定时器T1工作于连续增/减计数模式，产生三角载波，载波频率为3000Hz，载波比N=60，因此调制波形正弦波的频率为50Hz。本实验中，调制度为  0.8。 预存A相和B相的正弦值列表，C相的可以根据A相和B相的值计算出来

ucosII v2.86在dsp28069上的移植，编译环境为ccs v4.2.4，压缩包中包含全部文件，下载解压后，导入ccs4中，就可以编译连接，下载验证。 80MHz CPU Freq, 0.001 second Period，本程序建立了4个任务，时钟tick为1ms。

介绍了较流行的DSP中FFT算法.可以用在DSP中,也可以另做他用.-of the most popular DSP FFT algorithm. The DSP can be used, you can also do other purposes.

TI公司C6000系列DSP（DM642）液晶屏驱动源代码-TI Corporation C6000 Series DSP (DM642) LCD driver source code

DSP2812RAM,LED测试程序,可下载,烧写,可运行 -DSP2812RAM, LED testing procedures, can be downloaded, programmer, can run

ccs下汇编实现的fir滤波器，希望对大家有用-ccs achieve compiled under the fir filter, it may be useful to hope

MAX6951是紧凑的共阴极显示驱动器，可通过SPI、QSPI、MICROWIRE兼容的串行接口将微处理器连接到独立的7段LED数码管、条形图或分立LED。本程序利用TI公司DSP LF2407A 实现MAX6951驱动6位7段数码管。硬件连接采用IOPC0做片选信号，片上SPI外设与MAX6951通信。绝对原创，首次共享！-MAX6951 is a compact, common-cathode display driver is available through SPI, QSPI, MICROWIRE-compatible serial interface microprocessor connected to a separate 7-segment LED digital tube, bar graph, or discrete LED. This procedure using TI" s DSP LF2407A achieve MAX6951 driving six 7-segment digital tube. IOPC0 to do with the hardware to connect the chip-select signal, on-chip SPI peripherals communicate with the MAX6951. Absolutely original, for the first time to share!