简易正弦波发生器方案，同时提供全正数的正弦表

硬件要求：基于合纵达的SEED-VPM642的示例。软件要求：CCS2.2以上版本。对于想用DSP/BIOS开发的同道中人来说是很好的学习实例。-Hardware Requirements: Based on the combined vertical up the SEED-VPM642 example. Software Requirements: CCS2.2 above. For want to use DSP/BIOS development for the fellow human is a very good learning examples.

开关磁阻电机的速度控制程序，电流用的是滞环控制，控制器采用TI公司的DSP TMS320LF2407，开发环境采用TI提供的CC2000或者CCS-Switched Reluctance Motor speed control procedures, using current hysteresis control, the controller using TI

DSP/BIOS Driver Developer Kit 1.11 The DSP/BIOS Driver Developer Kit (DDK) provides a selection of pre-tested DSP/BIOS device drivers, and documentation on how to write a driver to the DSP/BIOS driver model, known as IOM. The DDK includes C source code for all drivers. The DDK 1.11 has been validated with CCS 3.1 and DSP/BIOS 5.20. -DSP/BIOS Driver Developer Kit 1.11 The DSP/BIOS Driver Developer Kit (DDK) provides a sel ection of pre-tested DSP/BIOS device drivers, and documentation on how to write a driver to the DSP/BIOS driver model, known as IOM. The DDK includes C source code for a ll drivers. The DDK 1.11 has been validated with CCS 3.1 and DSP/BIOS 5.20.

电力系统远动子程序,已经完全调试通过,方便使用TI公司2407DSP的同行应用,请放心使用-Power system telecontrol subroutines, debugging has been fully approved, to facilitate the use of TI company 2407DSP peer application, please rest assured that the use of

TMS320LF2407与图形液晶显示模块接口及应用，C语言，可在CCS下运行-TMS320LF2407 and graphic LCD module interface and applications, C language, can be run in CCS

ＤＳＰ２０００开发例程-DSP2000 development routines

该代码采用c5400dsp的汇编语言和c语言实现语音adpcm压缩与解压的程序，接口为同步串口，抽样速率为8k/s。-c5400dsp of assembly language and c language voice mode compression and decompression procedures for synchronous serial interface, and the sampling rate of 8k/s.

这是一个关于ADI的DSP平台ADSP218X系列的仿真软件工具的一个文档，希望对大家有帮助-This is an on ADIÚX DSP platforms ADSP218X series of simulation software tools a document, I hope it will be helpful for you .

LED128x64OLED显示屏(0.9 寸)底层驱动 适用于 DSP MSP320F28335 处理器

ADI公司ADSP-TS101S的看门狗电路控制程序-ADI"s ADSP-TS101S watchdog circuit control procedures