Labview实例

基于labview测正弦信号频率，使用FFT的算法，然后进行波峰检测(Based labview measured frequency)

matlab code for image processing

本项目是以 LabVIEW 为开发平台的环境监控与预警系统，实现了对温度，烟雾和电压电流等信号的实时采集、记录、存储和回放等功能程序的模块化设计，从而达到环境监控的目的。(This project is an environmental monitoring and early warning system based on LabVIEW. It realizes the modular design of functions such as real-time acquisition, recording, storage and playback of signals such as temperature, smoke and voltage and current, thus achieving the purpose of environmental monitoring.)

说明：  阈值分割，实现多种方法的阈值分割，单灰度区间图像分割、多目标聚类分割、迭代聚类法分割。(Threshold segmentation, to achieve a variety of methods of threshold segmentation)

基于labview的FIR数字滤波器课程设计文档，附vi程序(FIR digital filter based on LabVIEW curriculum design document, attached to the VI program)

利用labiew主程序实现单片机与主机的串口通信，实现温度的采集，然后通过比例积分算法的控制，输出一定占空比的波形驱动电机，实现恒温水箱的控制系统(MCU and host serial communication labiew main program, to achieve the acquisition of temperature, and then through the control of the proportional integral algorithm, the output of a certain duty cycle waveform drive motor, constant temperature water tank control system)

说明：  通过labview实现tcp协议的通信，可以使用虚拟串口和电脑通信(The communication of TCP protocol can be realized by labview. Virtual serial port and computer communication can be used.)

LabVIEW环境下动态载入技术，个人编写的，在8.5版本下可以运行，很好的！(LabVIEW environment, dynamic loading technology, personal written version may be run at 8.5, very good!)

说明：  对于无法实现硬件定时的数据卡来说，这个vi提供了软件定时的功能(For data cards that cannot achieve hardware timing, this VI provides software timing capabilities)

5.3 Empleando lazos y estructuras de control de flujo, elabore un programa que permita obtener sobre un mismo gr