Display clock.

PowerPac GUI用户使用手册-PowerPac GUI user" s guide. . . . . .

用端口模拟的IIC程序,可以在没有IIC总线的芯片使用.C语言编辑,可以任意移植到其它的芯片.该程序在freescale芯片测试通过-IIC with the port simulation program, you can not use the IIC bus chips. C language editor, can be ported to any other chips. The program freescale chip test

里面包括了minigui的介绍，编程，下载地址和事例的说明-Minigui which includes the introduction, programming, download the address and description of cases

本程序是显示模块的例程，所接器件为四位八段led数码管，其中PTB0-PTB3 与数码管的位选相连接，PTB4，PTB5与74LS164连接确定你开发板上拨码开 关JP1（图片上的12）的两位和JP4（图片上的9）的5、6、7、8位处于on）， 而其他位处于远离on！-This procedure is the routine display module, the access device for four eight led digital tube, which PTB0-PTB3 bit digital tube and connected to the election, PTB4, PTB5 with 74LS164 sure you connect the development of on-board DIP switch JP1 ( picture on the 12) two and JP4 (picture on the 9) of 5,6,7,8 located at on), while the other located at far away from the on!

鼠标驱动程序原代码，在linux下运行，非常好的资料-mouse-driven program source code in linux running, very good information

我写的ARM PS2驱动程序，使用普通GPIO口模拟PS2协议，可直接驱动键盘、条码找描枪等设备，并将从键盘、条码扫描枪等输入的信号通过UART口传至PC机-I write ARM PS2 driver, I use ordinary GPIO simulation PS2 agreement can be directly driven keyboard, bar code depiction find guns and other equipment, and from the keyboard, barcode scanning guns and other input signals through UART I conveyed to PC

嵌入式面试指针经典 嵌入式面试指针经典 -the c program the c program the c program the c program

基于mips cpu,在u-boot系统下磁盘驱动程序。-Based on mips cpu, in the u-boot system disk driver.

在VC编程环境下，linux图形用户界面设计（控件，按钮等），c程序源代码-in VC programming environment, linux graphical user interface design (controls, buttons, etc.), c source code