Part of the latest F2 Series external modules Chinese PDF, from the translation...

pci驱动程序的源代码-pci driver source code

温度传感器ds18b20程序，在lpc2103上调试通过-Temperature sensor ds18b20 procedures, the debugging lpc2103 by

D12 USB设备控制芯片驱动程序代码，是学习USB设备驱动编程的好资料-D12 USB device controller driver code, is a USB device driver programming learning good information

三星s3c44b0芯片下的设备转换的程序-Samsung S3C44B0 chips under the equipment conversion procedures

STM32平台下的MPU6000六轴驱动，SPI通讯接口。采用brust read，一次读取6轴数据和温度，减少读取时间

基于HCS12 单片机设计一种智能车系统。在该系统中,由红外光电传感器实现路径识别,通过对小车速度的控制,使小车能按照任意给定的黑色引导线平稳地寻迹。实验证明: 系统能很好地满足智能车对路径识别性能和抗干扰能力的要求,速度调节响应时间快,稳态误差小,具有较好的动态性能和良好的鲁棒性。-Based on the HCS12 MCU design an intelligent vehicle system. In this system, the path from the infrared photoelectric sensor to achieve recognition, through the car speed control, so that any given car in accordance with the black guide lines smooth tracing. Results show: The system can be well positioned to meet smart cars on the path to identify the requirements of performance and anti-jamming ability, speed adjustment quick response time, steady-state error is small, has good dynamic performance and good robustness.

通过STM32F303高级定时器TIM1产生PWM波形，STM32F303输出六路互补PWM波形初始化程序（可通过霍尔测速采集转变PWM占空比）

通过7路AD转换，结果存至相应存储单元--Convert by 7 route AD, and store the result in corresponding memory.

ucosII在arm920T内核s3c2410移植的代码.-ucosII in arm920T s3c2410 transplant kernel code.

ADC转换，串口发送命令开启一次ADC,并将结果通过串口发送到PC,任意字符开始-failed to translate