一个VC++编写的串口通信程序，可以通过串口发送和接收数据，并输出日志，也包含串口通讯中参数的设置...

最初学习写单片机串口通讯时的源程序，可以让初学者参考一下！-first learn microcontroller serial communications at the source, so that beginners can take a look!

用vc自带的插件开发串口通信源程序-vc onboard with the development of plug-in serial communications source

一个uart的Verilog代码，希望能够帮助你做UART逻辑。-Code about uart. You can use it as an example when desighn UART logic.

QCOUNTER,用来测试所安装板卡的事件发生总量。可重复加载-QCOUNTER, used to test the board installed by the total incident. Repeat the load

大学汇编课程设计程序及文档（双机串口文件传输）,开发环境TurboC-compilation of the University of curriculum design procedures and documentation (two aircraft serial file transfer), the development environment TurboC

W77E58双串口通信源代码 注：此源程序只作参考，内有些函数未有原型，借鉴在于其通信方式及其设置。 CRC检校可另参考其它代码。 -W77E58 dual serial communication source code Note : This program is for reference only, not some function prototype experiences in his means of communication and set up. CRC calibration can be a reference to other codes.

串口通信.在编程过程中，一些控件的属性读者不必完全按照示例程序去做-Serial communication. In the programming process, some readers do not have control of the property in full accordance with the example of the procedure to do

3.CB_seri.cpp(C++Builder串行异步通信程序)-3.CB_seri.cpp (C Builder asynchronous serial communication program)

主要是测试msp430x44x的读写，看能不能顺利读写！-mainly msp430x44x literacy test, whether we can successfully read and write!

向串口发送数据，在从串口接数据，需要注意的是把2、3脚短路。-to send data from the serial data access, it needs attention is 2,3 feet short.