本程序是用VB编写的有关于一个串口通讯的子和序。

一个简单的电脑红外遥控驱动程序，只能识别特定的红外信号（我是基于K11B遥控器编的），不能自动识别，还有一些简单的，控制其它程序的方法-A simple computer infrared remote control driver, could only identify a specific infrared signals (I was compiled based on the remote control K11B), does not automatically recognize, there are some simple method of controlling other programs

rs232的通讯程序,可以用文本方式定义协议-RS232 communication procedures can be defined as text agreement

VC的COM口驱动程序,使用了ACTIVEX控件-VC COM port drivers, the use of Activex Control

详细介绍了在Windows环境下应用VC与PC机和单片机进行串行通信的几种方法，我们用visualc6.0编写了PC机与C51单片机的通信程序。经实际应用系统运行稳定可靠。

串口通信控制XX变频器,VB下编的界面，已调试通过，可以运行，-VB_rs232_transducer

本程序是i2c总线读写一个字节的程序。在写过程序中，不一定非要检测i2c的应答位，可以直接延时过去就行，但是在读过程中必须给应答信号，读完发停止位，一定确认所发的信号都发上了。否则在连续地址读的过程中可能不会出错，但是在随机度过程中就会出错，我的程序就是在给停止信号时没有给上，24cxx一直在输出数据，结果读出错。找着问题后我的程序只加入了一条命令便完全正常。-i2c bus read and write a byte procedures. The written procedure, not necessarily require the detection i2c-response, and can directly past trip delay, but the process must be read to the response signal, stopped at reading, we recognize the signals are on the fat. Otherwise, the address read for the course could not go wrong, but the randomness of the process would be a mistake, I was in the process to stop for no signal, 24cxx in output data, read errors. I discovered the problem after the procedure just joined the order of a completely normal.

个人写的一个串口通讯程序，希望对大家有帮助。-personal wrote a serial communication program, and I hope to be helpful.

VB通过串口控制单片机读写24C02源代码-VB to read and write through the 24C02 single-chip serial port to control the source code

串口调试非常有用。 2103 arm-Serial debugging is very useful. 2103 arm

Manual_SIM300 detailed description