-
MPS430 used to control projects, and the U.S. share
采用MPS430控制的项目,和大家分享一下-MPS430 used to control projects, and the U.S. share
- 2022-02-20 22:49:37下载
- 积分:1
-
TLC5615的驱动程序,调试通过了
TLC5615的驱动程序,调试通过了--Driver program for TLC5615.
- 2022-06-12 15:21:22下载
- 积分:1
-
嵌入式linux下开发的必备uClibc,这是最新版的源码uClibc
嵌入式linux下开发的必备uClibc,这是最新版的源码uClibc-0.9.28,也可以到www.uclibc.org下载。-embedded Linux development under the prerequisite uClibc, the latest version of uClibc source-0.9.28, can be downloaded to www.uclibc.org.
- 2022-04-09 18:49:43下载
- 积分:1
-
用c语言编写MP3 源程序,使用时只需要把数组中代码替换成你想换的歌曲即可...
用c语言编写MP3 源程序,使用时只需要把数组中代码替换成你想换的歌曲即可 -c language used MP3 source files, using only array code should replace you want to change the song can be
- 2022-07-04 19:05:56下载
- 积分:1
-
这是液晶显示器的320×240 LPC2478的源程序实例
lpc2478中开发板上LCD显示的源码程序lcd大小为320*240-this is an example for lcd of 320*240 lpc2478 source program
- 2022-02-03 00:55:32下载
- 积分:1
-
Small RTOS(51)源代码、应用问答集.zip 可用于嵌入式51系统。
Small RTOS(51)源代码、应用问答集.zip 可用于嵌入式51系统。--Source code for small RTOS(51), and Q&A. It could be used in embedded 51 system.
- 2022-08-03 13:50:46下载
- 积分:1
-
利用8051的定时器用来计数作为频率计的基础。测频范围是1
利用8051的定时器用来计数作为频率计的基础。测频范围是1--10000HZ-The use of 8051 timer used to count as the basis of frequency. Measuring frequency range is 1 10000HZ
- 2022-11-27 07:55:02下载
- 积分:1
-
good information! Vc and the LabVIEW programming
很好的资料!vc++与labview的交互编程---在vc环境下调用labview下生成的dll库-good information! Vc and the LabVIEW programming-- in the interactive environment called vc labv iew generated in the library dll
- 2022-04-10 04:15:47下载
- 积分:1
-
L298N是ST公司生产的一种高电压、大电流电机驱动芯片。该芯片采用15脚封装。主要特点是:工作电压高,最高工作电压可达46V;输出电流大,瞬间峰值电流可达3A...
L298N是ST公司生产的一种高电压、大电流电机驱动芯片。该芯片采用15脚封装。主要特点是:工作电压高,最高工作电压可达46V;输出电流大,瞬间峰值电流可达3A,持续工作电流为2A;额定功率25W。内含两个H桥的高电压大电流全桥式驱动器,可以用来驱动直流电动机和步进电动机、继电器线圈等感性负载;采用标准逻辑电平信号控制;具有两个使能控制端,在不受输入信号影响的情况下允许或禁止器件工作有一个逻辑电源输入端,使内部逻辑电路部分在低电压下工作;可以外接检测电阻,将变化量反馈给控制电路。使用L298N芯片驱动电机,该芯片可以驱动一台两相步进电机或四相步进电机,也可以驱动两台直流电机。-L298N is produced by ST a high-voltage, high current motor driver chip. The chip uses 15-pin package. Main features are: high voltage, the maximum working voltage up to 46V output current, instantaneous peak current up to 3A, continuous operating current of 2A rated power of 25W. Contains two H-bridge high-voltage high-current full-bridge driver can be used to drive DC motors and stepper motors, relay coils and other inductive load using standard logic level signal control has two enable control terminal, input signal without affecting the case to permit or prohibit the device work a logic supply input, so that part of the internal logic circuits at low voltage work can be an external sense res
- 2022-02-05 00:53:15下载
- 积分:1
-
还是电子闹钟方面的,也是一个很好的程序,供初学者用
还是电子闹钟方面的,也是一个很好的程序,供初学者用-Or aspects of the electronic clock is a good program for beginners to use
- 2022-05-20 10:59:18下载
- 积分:1