I2c的通信协议 主控端。 没有写从端。不好意思

基于单片机的IDE硬盘控制的研究与设计.简单的介绍如何读写IDE-IDE hard drives based on single-chip control research and design. Introduce how to read and write simple IDE

HCS08例程：本程序是PWM模块的例程，所用资源为单片机内部TPM模块，所接器件为LED-HCS08 routines: This procedure is routine PWM module, the resources used for the single-chip internal TPM module, the access device for the LED

pic16-17单片机原理与应用，详细电子书籍-pic16-17 Single-chip Microcomputer Principle and Application, detailed e-books

Keil C做的8个LED灯循环左移右移-Keil C do eight LED lights cycle bits shifted to the right

8253的初始化程序举例: 例1：选择2号计数器，工作在3方式，计数初值为533H（2个字节），采用二进制计数。其初始化程序段为 MOV DX，307H ；命令口 MOV AL，10110110B ；2号计数器的初始化命 令字 OUT DX，AL ；写入命令寄存器 MOV DX，306H ；2号计数器数据口 MOV AX，533H ；计数初值 OUT DX，AL ；选送低字节到2号计数器 MOV AL，AH ；取高字节送AL OUT DX，AL ；后送高字节到2号计数器 -8253 initialization procedures examples : Example 1 : Select counters on the 2nd, in three ways. Counting for the initial 533H (2 bytes), a binary counting. Initialization of its procedures for MOV DX, 307H; I ordered MOV AL, 10110110B; on the 2nd Counter initialize command word OUT DX, AL; write commands Register MOV DX, 306H; data on the 2nd Counter I MOV AX, 533H; Counting initial OUT DX, AL; low-byte sent to the 2nd Counter MOV AL, AH; With a high-byte send AL OUT DX, AL; evacuations high byte counter to the 2nd

Keil写的320*240的液晶显示程序。很有参考意义。-Keil written 320* 240 LCD display program. Very useful.

用单片机控制红外编码探测障碍物。本文提出解决干扰的方案是：由单片机控制发射有一定意义的红外编码脉冲串，同时，单片机接收该脉冲串。如果接收到的信号和发射的信号基本一致，才判断为有障碍物的存在。-MCU control infrared obstacle detection coding. In this paper, to resolve the interference of the program are: the launch by the single-chip control has a certain sense the infrared encoder pulse train at the same time, single-chip microcomputer to receive the pulse train. If the received signal and the signals are basically the same as the launch only to have to judge the existence of obstacles.

显示字符与时钟,按键调试定时器, 3个按键可以设定时间,程序有8段时间段,时间到达每个时间段,9个输出相应变化.-Show the character and clock, timer debug button, three button can set the time, procedure time has paragraph 8, the time taken to reach each time period, the corresponding changes in the output 9.

基于pic18f2580实现的 定时器0程序 编译器为picc18-Based on pic18f2580 realize timer 0 program compiler for picc18