单片机和PC机通讯源程序 C语言编程 绝对好用

三路红外线探头控制ISD2560语音播放。主要原理是正常情况下三对红外线接收管接收到各自配套对应的红外发射管的红外线，属于正常检测状态，一旦有一路红外管信号被隔断，侧启动语音芯片程序，播报警示提醒语音或报警。三对红外管可以根据使用需要，设置搭配报警程序。可用于各种排队系统。-three-way infrared probe control ISD2560 voice broadcast. The main principle is that under normal circumstances receive three pairs of infrared receiver to control their own matching the corresponding infrared emission of infra-red and is a normal state of detection, if there is way infrared control signals are cut off, side launched procedures voice chip, broadcast a warning to remind voice or alarm. Three pairs of infrared tube can be used, the police procedures set match. For various queuing system.

CAN 程序使用MCP2515 由STM32做主芯片控制-CAN program use MCP2515 the mater chip is STM32

还可以吧我是新手不太懂请大家多多的指教好了-Can you not understand I am a novice please all sorts of good advice

图形点阵型LCD控制芯片ST7565R驱动程序，点亮全屏，并显示相关图片信息，已通过测试-Graphic point of formation LCD controller chip ST7565R driver, lit full-screen, and display the relevant image information, has been tested

单片机实现液晶显示程序，对初学者，比较实用-the mcu for lcd display

V型机LCD程序2005-11-5,V型机LCD程序2005-11-5-V-LCD procedures 2005-11-5, V-type LCD procedures 2005-11-5

简易红外线发射程序 使用低频率的发射 利用红外线二极管来做-simple procedure using infrared emission of low-frequency transmitters do using infrared diode

包内含有关于ipod mp3透反式1.46 tft液晶屏的avr示例程序和液晶屏转接板的protel原理图和pcb图。-Packet containing information on trans-ipod mp3 permeability 1.46 tft LCD screen avr sample procedures and LCD screen adapter plate Protel schematic and pcb Fig.

这是一篇关于嵌入式系统的LCD液晶驱动程序的资料及源程序-This is an embedded system on the LCD driver and source of information

LPC2103的第一个实验：流水灯，用proteus7仿真，C语言代码，在Keil3中编译，文件内已有完整的工程和仿真图了。-The first experiment LPC2103: water lamp, with proteus7 simulation, C language code, compiled at Keil3 in the paper that has a complete map of the engineering and simulation.