procedure for microcontroller development process, 1

基于arm单片机LPC2134上液晶显示器1602驱动源程序开发-Arm based on the LPC2134 Single-chip LCD driver 1602 source code development

低电压检测. A口低8位接键盘列线，键盘行线接VDDIO；B口高8位接LED // 按K1键 低电压为2.4v // 按K2键 低电压2.8v // 按K3键 低电压3.2v // 按K4键 低电压为3.6v

Visual Basic开发的单片机拨号程序，发送脉冲实现拨号，测试成功-Visual Basic develop MCU dial-up program, sending pulses to achieve dial-up, test the success of

红外通信的程序以及使用还有电路的设计大家可以参考使用-ZHX101

MSP430液晶控制程序，可以控制一般的12864液晶显示屏，短小，配合8M赫兹时钟频率-MSP430 LCD control procedures to control the general 12864 LCD screen, short, with 8M Hz clock frequency

本程序主要是16*2小液晶的驱动，可以显示英文字符和数字。-This procedure is 16* 2 small LCD drivers, you can display English characters and numbers.

AVR单片机入门及C语言高效设计实践（六） ATMEAG16L的定时／计数器 ATMEAG16L有两个8位定时／计数器（T／C0、T，C2）和一个16位定时／计数器T/C1）。每一个计数器都支持PWM（脉冲宽度调制）输出功能。PWM输出在电机控制、开关电源、信号发生等领域有着广泛的应用。[第一段]-AVR C language portal and efficient design practice (6) ATMEAG16L the timer/counter All ATMEAG16L two 8 timer/counter (T/C0, T, C2) and a 16 timer/counter T/C1). Each counter support for a PWM (pulse width modulation) output function. PWM output in motor control, switching power supply, signal and other fields has wide application. [Paragraph]

用于驱动24L01芯片的函数代码，老外写的，很漂亮！-24L01 chip used to drive the function code, written by a foreigner, very beautiful!

C51很好的IO模拟串口程序，也称软件UART。只需用一个定时器，实现中断接收。程序编写得很规范，有很多个晶振频率和串口频率可选。是一个比较好的软件串口程序。-C51 a good simulation of serial IO program, also known as the software UART. Just use a timer to achieve interrupt reception. Programming very standardized, there are many a crystal oscillator frequency and the frequency of an optional serial port. Is a relatively good software serial programs.

PL3106集成了52单片机，它具有电力线载波功能。本程序就是3106的载波发送和接受程序-PL3106 integrates 52 microcontroller, it has the power line carrier functions. This program is 3106 carrier to send and receive procedures