Huazhong University of Science and Technology School of Computer Interface Desig...

RS编码 CodeWarrior环境例程！-RS CW environmental routines!

介绍了在PPC硬件平台下,Windows CE操作系统中实现串口通信程序设计的通用方法-Introduced under the PPC hardware platform, Windows CE operating system, serial communication program design to achieve a common approach

采用C语言,软件模拟硬件UART端口,基于PIC系列处理器实现.-Using C language software simulation of hardware UART ports, based on the PIC family of processors to achieve.

一个模拟主站的CDT调试工具。可以根据需要来设置同步字，控制字，信息字的颜色。挺好用的。-A simulated Master Station CDT debug tools. May be needed to set the synchronization word, control word, the color information word. Very good use.

开发工具EmbeddedVC++4.0,GPRS网络接入源代码，WinCE环境-development tools EmbeddedVC 4.0, GPRS network access source code, WinCE

电机驱动监控系统，已经通过现场运行验证，绝对能用。-motor drive control system, has been verified through field operation, absolutely can be used.

本程序是通过串口，经由单片机控制电机转速的程序。该程序通过串口发送不同的信号，以实现控制通信。-this procedure is adopted Serial through SCM motor speed control procedures. The procedure adopted Serial send different signals to achieve control and communication.

getmywish使用的usb注意：由于用到多串口控制，需要在收到数据时确定是哪个串口来的数据。 下面是串口事件处理函数代码： -getmywish use usb Note : As used Multiport Serial control, the receipt of necessary data to determine which of the serial data. Below are the serial code incident handling functions :

串口通讯程序可以实现文件或字符的传送并可以自定义断口号-serial communication process can be achieved documents or characters and can be transmitted from the definition of off slogan

使用VC.NET编写串口通信程序，是很好的串口调试软件-Use VC.NET write serial communication program is a very good serial debugging software