LT_1B msp430开发板例子程序－UART_U96

万年历代码，在凌阳61单片机调试通过。 万年历代码，在凌阳61单片机调试通过。-Calendar code, in 61 single-chip debugging through Sunplus. Calendar code, in 61 single-chip debugging through Sunplus.

编写一个延时1MS子程序根据题目选择是定时还是记数状态，本题选择记数状态。然后根据延时1MS计算出计时器的初值是E0H（高8位）18H（低5位）。最后编写算法，对T0初始化，利用T0的中断TF0调用中断处理程序。-prepared a delay rungs subroutine under the topic chosen is not a time to memorize numbers or state of mind of the few options that state. According to delay timer rungs calculate the initial value is E0H (high 8) 18H (Low 5). Preparation of the final algorithm, the T0 initialization, interrupt the use of T0 TF0 call interrupt handling procedures.

一个关于温度计单片机的开发程序，使用c语言编写的-the process

利用430单片机内部得DA实现的DDS正弦波形产生程序，可以用在对输出波形稳定性很高的场合-430 single-chip internal use of DA may realize the DDS sine wave shape generation process, can be used in high stability of output waveform of occasions

带数字录音功能的控制器，更换源磁带。

C8051F020对74LS595的控制-C8051F020 control of the 74LS595

硬盘作MP3,用IDE接口的旧硬盘,加入51系列的单片机和显示屏,可以作一个有个性的MP3,-Hard drive for MP3, using the old IDE interface hard drives, adding 51 series of single-chip computer and display, can be used as a personality MP3,

芯片PCF8951共有四个A/D输入通道：AD0，AD1，AD2，AD3,分别与四个电位器(R1,R2,R3,R4)连接，用以调节电位器的输出电压。其中AD0通道既可测量电位器输出电压，也可用于测量从J1插座输入的外接电压，须用开关J2加以选择。J4插座提供由PCF8591输出的时钟方波信号。SAA1064驱动四个数码管显示一路AD转换后得到的数据。-PCF8951 chip, there are four A/D input channels: AD0, AD1, AD2, AD3, respectively, with four potentiometers (R1, R2, R3, R4) connected to regulate the output voltage potential. AD0 channel which can be measured potentiometer output voltage can also be used to measure the input from the J1 socket external voltage, to be used to select switch J2. J4 socket output from the PCF8591 clock square wave signal. SAA1064 drivers of four digital display along after AD conversion data.

我自己用单片机C语言写的一个抢答器，希望对大家有用-For my own use MCU C language written in a Responder hope for all of us

1302时间集成电路,在430上调试通过-1302 time integrated circuits, in the 430 debugging through