基于单

一款操作128x64 图形液晶显示屏的完整 C51 程序，里面有关于汉字及图形的显示程序-A 128X64 graphic LCD screen to operate the complete C51 procedure, which has on the characters and graphics display program

采用MCP2515的CAN通信代码，适合8位、16位AVR单片机-MCP2515 using the CAN communications code, suitable for 8-bit, 16-bit AVR Singlechip

便于单片机简单使用时钟功能的，对于初学者特别有用，只需要稍微懂得电路，了解做个电子时钟原理即可-Simple and easy to use single-chip clock function, particularly useful for beginners, require only a slight circuit to understand, understand to be a principle of the electronic clock to

红外遥控接收 ORG 0000H LJMP START 转入主程序 ORG 0010H START: MAIN: JNB P2.2,IR LJMP MAIN 以下为进入P3.2脚外部中断子程序，也就是解码程序 IR: MOV R6,#9 SB: ACALL DELAY882 调用882微秒延时子程序 JB P2.2,EXIT 延时882微秒后判断P3.2脚是否出现高电平如果有就退出解码程序 DJNZ R6, SB 重复10次，目的是检测在8820微秒内如果出现高电-infrared remote control receiver ORG 0000H LJMP START into main program ORG 0010H START : MAIN : JNB P2.2, IR LJMP MAIN below to enter P3.2 foot external interrupt subroutine, which is decoding procedures IR : MOV R6, SB# 9 : Calling ACALL DELAY882 882 microsecond delay subroutine JB P2.2, EXIT 882 microsecond delay after the judgment whether there P3.2 feet to I quit if decoding procedures DJNZ R6, SB repeated 10 times, the purpose is to test if within 8,820 microsecond high

USART以查询方式收发数据，接收发自电脑的数据，将其显示在LED上，并将接到到的数据减1后返回电脑-USART to send and receive data to query, receive from the bottom of the computer data that could be displayed in the LED, and will receive the data returned by a computer

我做过的一个步进电机驱动控制箱，单片机的完整程序，希望喜欢玩单片机的朋友可以借鉴学习一下-this is the project program of asm,which is used in step-motor controler.

Atmel Uart C51程序（timer2方式）-Uart (timer2 way)

x9313数控电位器的驱动函数，用于程控LCD对比度，-NC Potentiometers x9313 driver function for program-controlled LCD contrast,

pic18f2480的can模块初始化函数以及基本的收发操作-can the pic18f2480 module initialization function, as well as send and receive basic operation

炬力att7027仿真的说明程序还有开发板-att7027 simulation of the development process there plate