DK3400_3420 USB R_W source code

测试can总线好坏的vc源码-test can vc bus close to the source

pic18f2480的can模块初始化函数以及基本的收发操作-can the pic18f2480 module initialization function, as well as send and receive basic operation

1线通讯协议的c51例子程序, 已调试通过-One-line communication protocol procedure example of the C51 has been debugging through

飞利浦RC522芯片源代码。该芯片主要针对三表市场和手持设备，支持I2C/SPI/UART接口。 先发布基于普通51单片机的驱动源代码，采用串口接口，无需中断。只要接一个串口，后续会发布基于飞利浦LPC9401的读写源代码！LPC9401也是基于51核，只需连接SPI接口！有公司拿这个源代码卖钱哟-Philips RC522 chip source. The chip targeted at three tables and handheld devices market, support I2C/SPI/UART interface. Based on the first general release 51 MCU-driven source code, using serial interface, without interruption. As long as a serial port access, the follow-up will be issued based on the Philips LPC9401 write source code! LPC9401 is based on the 51 nuclear, only connecting SPI interface! A company with the source code acquisition yo! !

《单片机原理与实用技术》第1章-"SCM principles and practical technology," Chapter 1

TFT9320的驱动程序，可以使用在不同的平台中-TFT9320 driver, you can use in different platforms

本文主要编译出lcd的基本程序，还有字模的使用方法 -In this paper, compile a lcd basic procedures, as well as the use of matrix methods

主要用于液晶电视解码,内置51单片机,全部代码用C编写,编译环境为KEILC-Mainly used for LCD TV decoder, built 51 single-chip, all of the code prepared by C, the compiler environment KEILC

/// ////ADC0监控中断调试程序//////////////// /////////选择AIN0.3为ADC0转化输入，单端模式///// //调试时可采用变位器作为ADC输入源，调节其电压观察监控中断情况-/////// ADC0 interrupt debugger monitor ///////////////////////// AIN0.3 choice for ADC0 conversion input, single-ended mode/////// debug device when using variable-bit ADC as input source, adjust its voltage monitor to observe a break in

Luminary cotex-M3 CAN总线 源代码-Luminary cotex-M3 CAN bus source code