FM25040的C51驱动程序，用于掉电保存数据。

51单片机虚拟串口,解决只有P3.0/P3.1单串口的不足-51 single-chip virtual serial port, serial port solution is only the inadequacy of single-P3.0/P3.1

51单片机实用子程序库，含有详尽的单片机资源调用子程序-51 single-chip utility subroutine library, which contains detailed subroutine calls single-chip resources

C8051F340在应用中读写FLASH，我自己严格按照数据手册写的，在网上找了半天都没有的-C8051F340 in the application to read and write FLASH, my own data in strict accordance with the written manual, look online for a long time there was none

该程序是AD9856的驱动部分，驱动部分调试通过，稍作修改即可运用在产品中-AD9856 The program is part of the drive, drive through part of debugging, with some slight modifications can be used in products

RS译码主要模块的verilog代码，很有用也很实用的，需要的一定要看哦-RS decoding main modules of the verilog code, very useful and very useful, and we need to look at Oh sure

MCS-51单片机有5个中断源，其中两个是由-INT0、-INT1引脚输入的外部中断源；另外三个是内部中断源即由T0、T1的溢出引起中断和串行口发送完一个字节或接收到一个字节数据引起中断。触发外部中断有两种方式，即下降沿引起中断或低电平引起中断。当编程TCON中的ITi（i=0、1）为1时，则引起触发的方式为边沿触发方式，反之(ITi=0)为低电平触发方式。每个中断源的中断请求能否得到响应要受两级“开关”的控制，即一个总“开关”-MCS-51 single-chip has five interrupt sources, two of which are by-INT0,-INT1 pin input external interrupt source the other three internal interrupt sources from the T0, T1 overflow caused by the disruption and serial port sending or receiving end of a byte to a byte of data caused by interruption. Triggered external interrupt has two modes, namely, falling edge or low-level disruption caused disruption caused. When programming TCON in ITi (i = 0,1) for the 1:00 has been the subject of a way to trigger the way to the edge of the trigger, on the contrary (ITi = 0) for low-level trigger mode. Each interrupt source interrupt request can be subject to levels in response to

研究所积累的资料8,大家秘密使用,千万别告诉别人!-8 Institute of accumulated data, we use a secret, please do not tell others!

This small utility helps to generate seven segment display codes for different I/O connections. For example, AVR/PIC Port A.0 -> D Segment Port A.1 -> B Segment .... Also it can generate Common Cathode or Common Anode table codes.. I Coded it long time ago. I Hope help someone. Thank you

永磁同步电机监控程序，12864显示，AD采样-Permanent magnet synchronous motor control program, 12864 displays, AD sampling

点阵液晶取模取模软件，里面可以设置很多种方式，纵向取模与横向取模等可以适应各种LCD-Modulus modulus matrix LCD software, which can be set to very many ways, vertical and horizontal modulus modulus, etc., may adapt to a variety of LCD