Carefully collected some of their own energy meter design documentation as well...

智能车XS128芯片 LED测试程序.仅供参考-the progressing is just for test! With it,you can check your chip!

2003年全国大学生电子设计大赛-简易逻辑分析仪源码（示波器显示部分）凌阳61板开发-2003 National Undergraduate Electronic Design Contest- Simple logic analyzer source (oscilloscope display part) 61 Sunplus board development

通讯误码仪测试软件-communications software error Test

实现IEEE802。15。4协议的开发板的USB驱动，完成了高速数据传输-Realize IEEE802. 15. 4 protocol development board

利用动态扫描和定时器1在数码管上显示 出从765432开始以1/10秒的速度往下递减 直至765398并保持显示此数，与此同时利 用定时器0以500MS速度进行流水灯从上至 下移动，当数码管上数减到停止时，实验 板上流水灯也停止然后全部开始闪烁，3秒 后（用T0定时）流水灯全部关闭、数码管上 显示出"HELLO"。到此保持住。 设晶振频率为12MHz。-The use of dynamic scanning and Timer 1 in the digital control to show from the beginning of 765,432 to 1/10 seconds until the speed of descending down 765,398 and maintain display this number, at the same time the use of Timer 0 to 500ms the speed of light from the flowing water to Under the move, when reduced to a few digital tube stop, the experiment on-board water stop and then all the lights started to flicker, 3 seconds later (T0 regularly used) closed water lights, digital tubes show

C8051F411单片机的I2C接口通信程序,调试通过-C8051F411 MCU I2C interface communication program, debugging through

LT_1B msp430开发板例子程序－HFXT

DS18B20芯片的温度转换子程序精度为0.5-Temperature Conversion Subroutine

锯齿波产生程序 megal128 iccavr开发平台-Sawtooth generation process development platform megal128 iccavr

自己编写的一个单片机控制红外发送与接收的红外接收源程序,同时自己也做了一个板实验,是成功的哦-I have written a single chip to send and receive infrared control infrared receiver of the source, at the same time also made a plate experiment was a success, oh