非常有用的串口调试软件

ICCAVR_mega8_串口发送接收，c语言编写的！-Send ICCAVR_mega8_ serial receiver, c language!

Advantech Driver Demo : port I/O 软件修改 控制外板输出-Advantech Driver Demo : port I/O software change control plate output

LED 发送字模系统-LED Printer System

DOS环境下TC2/3源代码-TC 2/3 source codes under DOS

楼宇自控系统 顾名思意。 （注意：需要专用硬件支持。）-Building Automation System Advisory Board were thinking Italy. (Note : the need for dedicated hardware support.)

用VC++6.0实现PC机与单片机之间的串口数据交换-VC 6.0 PC with a serial port between SCM data exchange

介绍了如何用verilog语言实现处理器部件uart-Describes how to use Verilog language processor components UART

本串行通信程序利用汇编语言通过BIOS中断调用和DOS功能调用实现PC机双机串行通信。其中，上位机和下位机串行口均为辅串口COM2（口地址为2FXH），对外用9针连接器与令一台PC机连接；BIOS通过“INT 14H”4个中断服务子程序，分别完成串口初始化编程、发送一帧数据、接受一帧数据以及测试通信线状态。本程序分为PC机串口自动测试程序（目的是测试串口好坏）和PC机全双工双机通信程序两个部分。-the serial communications procedures through the use of assembly language BIOS interrupt calls and function calls DOS PC Dual Serial Communication. Among them, PC and the next crew will be supplemented by serial port Serial COM2 (I address 2FXH) external with 9-pin connectors and enable a PC connection; through the BIOS "INT 14H," four interrupt service routines, complete serial port initialization programming, Send a data receiving a data communications test and the state line. The procedures are divided into PC serial automatic test procedure (for the purpose of testing Serial good or bad) and full-duplex PC-machine communication program two parts.

六种列举当前所有的串口方法-six methods for handling serial ports

本程序是i2c总线读写一个字节的程序。在写过程序中，不一定非要检测i2c的应答位，可以直接延时过去就行，但是在读过程中必须给应答信号，读完发停止位，一定确认所发的信号都发上了。否则在连续地址读的过程中可能不会出错，但是在随机度过程中就会出错，我的程序就是在给停止信号时没有给上，24cxx一直在输出数据，结果读出错。找着问题后我的程序只加入了一条命令便完全正常。-i2c bus read and write a byte procedures. The written procedure, not necessarily require the detection i2c-response, and can directly past trip delay, but the process must be read to the response signal, stopped at reading, we recognize the signals are on the fat. Otherwise, the address read for the course could not go wrong, but the randomness of the process would be a mistake, I was in the process to stop for no signal, 24cxx in output data, read errors. I discovered the problem after the procedure just joined the order of a completely normal.