DEC6713 board to light up through the GPIO, LED out of the test procedure.

数字信号处理的一些方法，用C编写的，调试过，正确无误。-Some digital signal processing method, written in C, debugged, correct.

dsp2407关于I/O端口操作的汇编源程序，直接打开工程文件即可。-dsp2407 on the I/O port operation of the compilation of source code, you can directly open the project file.

S3C6400 srom controller,srom controller

dsp2812程序算法，在RAM中调试，已经调试通过-dsp2812

DEC6713板卡上通过GPIO来点亮、熄灭LED的测试程序。-DEC6713 board to light up through the GPIO, LED out of the test procedure.

dsp program

AD转把模拟量换成12位数据，把这12bit数据发送给DSP处理器-AD to replace the 12 analog data, this 12bit data sent to the DSP processor

提供了数字信号处理中sfft的Fortran子程序-Provides a digital signal processing sfft the Fortran subroutines

DSP入门教程 PDF电子书 -DSP Tutorial PDF eBook

MAX6951是紧凑的共阴极显示驱动器，可通过SPI、QSPI、MICROWIRE兼容的串行接口将微处理器连接到独立的7段LED数码管、条形图或分立LED。本程序利用TI公司DSP LF2407A 实现MAX6951驱动6位7段数码管。硬件连接采用IOPC0做片选信号，片上SPI外设与MAX6951通信。绝对原创，首次共享！-MAX6951 is a compact, common-cathode display driver is available through SPI, QSPI, MICROWIRE-compatible serial interface microprocessor connected to a separate 7-segment LED digital tube, bar graph, or discrete LED. This procedure using TI" s DSP LF2407A achieve MAX6951 driving six 7-segment digital tube. IOPC0 to do with the hardware to connect the chip-select signal, on-chip SPI peripherals communicate with the MAX6951. Absolutely original, for the first time to share!