我收集了Protel在封装的通用部件运行。他们中的一些人..

在QuartusII中使用AHDL语言编写一个RS232串行数据通信接口，要求设计输入输出端口，要求能提供的接收端口正确地接收。其中1bit作为start位，8bit作为数据，1bit作为end位。-QuartusII used in the preparation of an AHDL language RS232 serial data communication interface to design input and output ports, require the receiver to provide the correct port to receive. 1bit as one start bit, 8bit as data, 1bit as the end bit.

makefile examples with various makefiles

生成多项式的最高位必须是1。例如：CRC-CCITT标准的16位生成多项式：g（x）= x16+x12+x1+1；阶数r = 16 即：0x11021.最高位通常为1。-Generating polynomial must be the highest one. For example: CRC-CCITT standard 16-bit generation polynomial: g (x) = x16+ X12+ X1+ 1 order of r = 16 that is: 0x11021. Highest one usually.

通常的汉字显示方式是先根据所需要的汉字提取汉字点阵（如16×16点阵），将点阵文件存入ROM，形成新的汉字编码；而在使用时刚需要先根据新的汉字编码组成语句，再由MCU根据新编码提取相应的点阵进行汉字显示。在这种显示方式中，如果使用的流字数量较大或语句较多时，利用汉字的新编码组成语句将是一件十分繁琐而枯燥的工作。针对这种情况，本文提出了一种十分简单的方式――直接利用PC机的汉字内码作为单片机系统的编码。-Chinese characters are usually displayed in accordance with the need to first extract of the Chinese character dot-matrix (such as 16 × 16 dot matrix), will be deposited into the matrix documents ROM, a new Chinese character encoding while just need to use the Chinese characters according to the new code composed of statements, and then by the MCU according to the new code to extract the corresponding Chinese character dot-matrix display. In this show the way, if you use the word flow statement number of the larger or more, the use of Chinese characters composed of a new coding language will be a very tedious and boring work. In view of this situation, this paper presents a very simple way- direct access to PC-code character encoding as a single-chip microcomputer system.

基于制造商应用说明的atmel处理器中单线控制的源代码

pencil嵌入式系统开发包--A development package for pencil embedded system.

51的IO口模拟UARTRS232 波特率9600 Fosc：22.1184MHz 已在keilc51调试通过，运行畅快。-51 IO mouth simulation UARTRS232 Fosc 9600 Baud Rate : 22.1184MHz in keilc51 through debugging, running carefree.

此示例是为 STM32F3-discovery board写的。此示例的目的是展示如何使用独立看门狗 STM32F3 系列处理器上的。程序闪烁带领每隔 0.5 秒与定时器中断和外部中断 （在评估板上的蓝色按钮） 用来生成一个假的错误，以便处理器会跳转，而循环。它永远不会那里循环，因为 IWDG 会将重置处理器和领导会开始再次闪烁。代码是完整提出的意见，解释有写的是什么。这是写的手臂从 IAR 系统使用 IAR 嵌入式工作台。（并不是所有的库添加到此项目是必要的）。

uc/fs文件系统-uc/fs File System

这是基于altera的片上处理器nios 的一个IP电话终端的设计,来源altera的电子设计文章大赛.-This is based on the altera-chip processor Nios an IP telephone terminal design, the source of the electronic design altera article contest.