好用的阴影去除算法，matlab编写

滚降系数为0.5，载波频率fc=40/T.基带信号的频谱和幅度已调信号的频谱。(Roll-off factor of 0.5, the carrier frequency fc = 40/T. base-band signal spectrum and amplitude spectrum signals have been transferred.)

模式识别中的聚类算法，读取文件，实现K均值的分类。(Pattern Recognition in the clustering algorithm to ensure that you can run the)

说明：  小波变换滤波的matlab程序的实现用于图像的背景抑制(Wavelet filter for image matlab program to achieve the background suppression)

说明：  LMI 实例H∞ state feedback control for generalized continuous/discrete time-delay system☆(LMI CONTROL TOOLBOX)

2*2 mimo-ofdm channel simulation matlab code

K分布海杂波程序，用matlab尽心仿真(K Distribution Sea Clutter program)

Using the PSO the LSSVM the parameter, the optimal parameters, more accurate classification.

说明：  基于遗传算法的均匀直线阵列方向图优化和相位分布(Pattern optimization and phase distribution of uniform linear array based on genetic algorithm)

说明：  产生高斯混合倾斜噪声，用于目标跟踪领域，matlab代码需要解压后使用(Gaussian mixture skew noise is generated for target tracking)

The model used for creating the reference voltage is shown in Fig. 4. First, photovoltaic output current (Ipv) and output voltage (Vpv) are passed through a first order low pass filter with a magnitude of G = 1 and a time constant of T = 0.01 seconds in order to filter out the high frequency components or harmonics from these signals as shown in Fig. 5 and Fig. 6. The filtered current and voltage signals (Ipv_F and Vpv_F) are then fed into the MPPT control block that uses the Incremental Conductance Tracking Algorithm. An algorithm that is based on the fact the slope of the PV array power curve shown in Fig. 7 is zero at the Maximum Power Point (MPP), positive on the left of the MPP, and negative on the right. The MPP can thus be tracked by comparing the instantaneous conductance (I/V) to the incremental conductance (∆ I/∆ V) [11] as in (1):