linux2.6.22移植到S3C2410补丁 只要把原来的linux2.6.22.2解压后，再用这个补丁包覆盖上去，即可移植到2410...

成都理工大学基于MAXPLUS II 的设计过程报告内涵有源程序及设计过程中的调试：在文本编辑窗口中输入二进制8位优先编码器的程序； 3设计驱动显示程序如下： 5采用原理图方式设计如下： 6引角分配图如下： 7仿真结果如下： -Chengdu University of Technology II-based FPGA design process report connotation source and the design process Debugging : in the text editing window importation of eight priority binary coding of procedures; 3 shows the design-driven procedures are as follows : 5 diagram using design methods are as follows : 6 primers angle distribution plan are as follows : 7 simulation results are as follows :

发电CPLD家族的前十分之一MAXⅡ器件动态功耗很低，所以低功耗运行。MAX II系列价格低廉，功耗是MAX 3000A系列的十分之一。

自动升降电梯控制器设计 要求： 设计一个6层楼的电梯控制器。 该控制器可控制电梯完成6层楼的载客服而且遵循方向优先原则，并能响应提前关门延时关门，并具有超载报警和故障报警； 同时指示电梯运行情况和电梯内外请求信息。-Auto-Lift elevator controller design requirements: design of a six-story elevator controller. The controller can control the completion of six-story elevator containing the principle of giving priority customer service, and follow the directions, and can respond to close ahead of schedule delay closing, and has overload alarm and fault alarm also instructed the elevator and elevator operation request information both inside and outside.

stm32f4-为开发基本支持STM32F4发现板 将 config.mk.example 复制到 config.mk Set TOOLCHAIN向你的手臂皮质 m4 工具链的前缀 Set FREERTOS_PATH为您的 FreeRTOS 源的路径 类型make 测试套件跟前男友： STM32F401C 迪斯科 请点击左侧文件开始预览 ！预览只提供20%的代码片段，完整代码需下载后查看 加载中 侵权举报

其中包括ＣＡＮ节点初始化程序，发送和接收程序-including CAN node initialization procedure, the sending and receiving procedures

三星s3c44b0芯片下的基本模数转换程序

msp430开发c语言例程--MSP430 development ( C code).

mpc860中断管理及其实例代码-mpc860 interrupted management and its code examples

本程序使用一个定时器和任意的2个I/O口模拟一个串口通信。可以直接调用。-This procedure uses a timer and any two I/O port simulation of a serial communication. Can be directly called.

广东嵌入式的一款开发板的使用手册，详细介绍了开发板的程序和开发资料。-Guangdong, an embedded development board s manual, detailing the development process and development of information boards.