TI的2.4G芯片CC2500的开发资料,PDF,程序,原理图都有了,PCB不知啥软件做的,打不开....

这是在KEIL环境下写的CAN源码，具有CANOPEN协议，学习参考的好东西哟！-This is in KEIL environment CAN write source code, with CANOpen agreement, a reference to learn good things yo!

KEIL C51使用方法的介绍!非常详细,非常实用-KEIL C51 using the method of introduction! Very detailed, very useful

我编写的基于spce061a的语音播报电子钟,利用sunplus开发板，可以设置时间和定闹 陈谭 2004 -I prepared based on the voice broadcast spce061a electronic bell, using sunplus development boards can set time and set downtown Chen Tan 2004

can_bus_protocol_2.0b CAN总线协议-can_bus_protocol_2.0b CAN bus protocol

利用脉冲控制伺服电机运转，伺服电机频率通过改变定时器初值来控制-The use of pulsed operation of servo motor control, servo motors by changing the timer frequency to control the initial value

实现stc单片机，两个单片机之间的SPI通讯。单主单从-Stc achieve single-chip, two single-chip communications between the SPI. Single-master single from

PCI_Express PCB Guidelines

1． 利用单片机内部的T0，T1计时计数器产生中断，并通过单片机最小系统按键产生外部中断，利用单片机中断系统闹钟的走时，调整及报数功能。-1. The use of single-chip within the T0, T1 timing counters generate an interrupt, and the smallest single-chip systems have external interrupt button, using single-chip system clock interrupt the travel time, and adjust the number of features reported.

用STC单片机开发的简单脉冲发生器,用来测试步进驱动器.-With STC to develop a simple single-chip pulse generator, to test the stepper drive.

EM4001,EM4100等系列只读ID卡读取程序源码-EM4001, EM4100 series of CD-ID card reader FOSS