U组开发源代码，FAT16文件系统的源代码，FLASH间…

红外遥控接收 ORG 0000H LJMP START 转入主程序 ORG 0010H START: MAIN: JNB P2.2,IR LJMP MAIN 以下为进入P3.2脚外部中断子程序，也就是解码程序 IR: MOV R6,#9 SB: ACALL DELAY882 调用882微秒延时子程序 JB P2.2,EXIT 延时882微秒后判断P3.2脚是否出现高电平如果有就退出解码程序 DJNZ R6, SB 重复10次，目的是检测在8820微秒内如果出现高电-infrared remote control receiver ORG 0000H LJMP START into main program ORG 0010H START : MAIN : JNB P2.2, IR LJMP MAIN below to enter P3.2 foot external interrupt subroutine, which is decoding procedures IR : MOV R6, SB# 9 : Calling ACALL DELAY882 882 microsecond delay subroutine JB P2.2, EXIT 882 microsecond delay after the judgment whether there P3.2 feet to I quit if decoding procedures DJNZ R6, SB repeated 10 times, the purpose is to test if within 8,820 microsecond high

飞思卡尔单片机.推荐给大家看利用CodeWarrior的PE功能生成SPI模块的参考代码一下.-Freescale Singlechip. Recommended for everyone to see use of CodeWarrior to generate the PE functional SPI module reference code look.

关于9s12单片机的课件 重点是编程语言和环境-on 9s12 SCM courseware focused on programming language and environment

一种基于DSP技术的配电网实时监测与故障诊断装置-a DSP-based technology distribution network-monitoring and fault diagnosis device

凌阳的LCD演示原码,里面还有LCD的使用说明.

可用于 51系列单片机与触摸屏之间的通讯 （一般用modbus实现通讯）-design for exchange massage both mcu51 and torch pad

CC2430 基础实验二 按键控制开关实验-CC2430 experimental basis experiment 2 button control switch

NXP的mifare ultralight　数据手册, 英文版本,完成对电子标签的操作.-NXP" s data mifare ultralight manual, English version, the completion of the operation of electronic tags.

文件中包括：串口通讯程序，以及两个单片机通过串口通讯的程序。-Document include: serial port communication program, as well as two single-chip serial communication through the process.

单片机模糊设计开发系统原代码-SCM fuzzy design development system source code