USB规范协议1.1的翻译稿

该程序用以通过单片机来控制芯片CH375 实现对海量存储器的读写操作-procedure for the adoption of the single-chip microcomputer to control chip to achieve CH375 Massive Memory read and write operation

usb通用的驱动程序，特别好用-USB generic driver, especially handy

Realize the usbip function, which could be simulate usb port through net

2407上ucosii移植实现，值得参考-2407上ucosii移植实现，值得参考！！！！！！！！！！！！

USBhost source

D12的驱动程序-D12 driver

USB设备端固件程序,枚举部分是全部程序的基础和重心,只有主机对设备枚举成功后,主机才能和设备进行正常的通信 USB的枚举过程分为4个状态. 1.接入态 v主机检测到USB设备插上,击活端口,并发送复位命令(保持10ms) 2.默认态 v主机使用默认地址读取设备描述符 (GET_DESCRIPTOR) v主机分配给设备一个总在线的唯一地址 (SET_ADDRESS) 3.地址态 v主机从新的地址获取设备描述符(GET_DESCRIPTOR) v主机获取所有设备的配置描述符(GET_DESCRIPTOR) 4.配置态 v主机设置描述符(设备,配置) (SET_CONFIGURATION) v主机读取配置状态(可选) (GET_CONFIGURATION) v主机读取接口状态(可选) (GET_INTERFACE) -USB device-side firmware, enumerate all part of the foundation and focus of the procedure, only the host of equipment after the successful enumeration, the host and equipment in order to engage in normal communication USB enumeration process is divided into four status. 1. Access state v host detected USB devices plug in, hit live ports, and send the reset command (to maintain 10ms) 2. default state v Use the default address of the host to read device descriptor (GET_DESCRIPTOR) v host assigned to the equipment of a total online only Address (SET_ADDRESS) 3. A

上传了一个批量传输得IN程序，现在上传的是EZ-USB FX2的批量传输的OUT程序-posted in a batch transmission IN procedures, now upload the EZ-USB FX2 the bulk transmission procedures OUT

usb 代码 用VHDL编写 方便初学者使用 学习 有什么不明白的 大家可以回复 互相交流-usb using VHDL code to facilitate the preparation of beginners to learn what we do not understand each other can return exchange

USB 1.1 协议中文版-USB 1.1 protocol Chinese version