直流电机闭环控制C程序，包括方向、转速的控制和补偿算法等...

89c52 eprom 的子程序 可以参考一下 -89C52 eprom the subroutine can reference

AD9850资料，内有源程序代码，可以给大家提供一个模本。-AD9850 data, which has source code, can provide a mode of the U.S..

msp430 f2x系列单片机示例代码，包括各个片内外设模块的驱动示例。-msp430 f2x Series Singlechip sample code, including all-chip peripheral modules, sample-driven.

自行开发的51单片机电子钟程序，且带有上位机通讯的功能。-self-developed electronic bell 51 SCM procedures and communication with PC functions.

DAC0832可调频的程序，用C语言编写，希望对大家有帮助-FM DAC0832 procedures can use C language, and they hope to have everyone help

6段数码管分别显示，时，分，秒，四个按键，K1（P0.0），K2（P0.1）， K3（P0.2），K4（P0.3），四个按键用来调时间的，按下K1，所有位都清零显示，然后按下K2，秒在闪烁，继续按K2分闪烁，不段地按K2 秒--分--时切换着闪烁，在某位闪时按下K3相应位加一，确认调整，按K4，取消调整再按K1。在K1按下以后才有调时的功能，如果K1没有按下，按别的键没有反映。这为了在加点按键功能留着用 -6 respectively of the digital control, when, minutes and seconds, four keys, K1 (P0.0). K2 (P0.1), K3 (P0.2), K4 (width), the four keys to the transfer time, press the K1, All spaces are reset, then press K2, the scintillation seconds, according to K2 pm flickered. not according to K2 of seconds-- minutes-- when switching to flicker in certain press the flash-K3 corresponding increase in a confirmed adjustment by K4, then canceled K1 adjustment. K1 in the press will only be made after the transfer of function, if K1 pressed by other key is not reflected. This points to the function keys used Retention

51单片机串口通讯程序-51 monolithic integrated circuit string mouth communication procedure

what i s just what we very much need ,jus t give it to you

单片机C语言开发软件KEIL C，该软件上手容易，适宜于各个阶段的单片机爱好者-Singlechip C language development software KEIL C, the software easier to use, suitable for all stages of the single-chip lovers

PIC16F877控制LED进行任何显示，该源码只做了北京两个字的显示-PIC16F877 to control LED of any revealed that the source only the word display in Beijing