sdt文件移植为ads文件配置的改变

PLC控制日本安川伺服电机的源程序。控制方式为串口控制，按顺序发送相应指令。-PLC Yaskawa Japan servo motor control of the source. Control mode for the serial control, according to the order to send the corresponding commands.

uC/OS移植到x86上的范例１，可以稍做参考。-uC/OS to x86 on a paradigm that can be a little reference.

资源描述本源码使用STM32的硬件IIC接口方式实现IIC总线，读取EEPROM的数据。注意：使用STM32的硬件IIC接口存在一些小小的技巧，ST公司使的总线时序比例与NXP和ATMEL公司的不太一样。

下载的一些重要的电子设计文档，包扩电路原理图和PCb-Download some of the important documents in electronic design, including the widening of the circuit schematic and PCB

WINHEX11V2 显示磁盘及文件信息-WINHEX11V2- show disk and file information

摩托罗拉的脉冲信号输出的原代码-Motorola pulse signal output the source code

一个免费的I2C操作工具,可以对指定的I2C设备进行读写。是新手学习的好工具。

T-Ker测试synchronization_communicationsemaphore部分的tk_cre_sem,tk_del_sem, tk_sig_sem, tk_wai_sem, tk_ref_sem在移植的uT-Engine上运行是否正常。 api的返回值正确与否，在ads上设断点观察，同时用Lpc2104上的LED显示（如果正确，则程序中设定的LED就闪亮）nel中的flag小实验程序-T- Ker test synchronization_communication tk_cre_sem part of the semaphore, tk_del_sem. tk_sig_sem, tk_wai_sem. tk_ref_sem transplantation in the UT-Engine running normal. Api return to the correct value, based on the ads breakpoint observation, Lpc2104 using the LED display (if correct, procedures were set on the flashing LED) nel flag of the small experimental procedure

本程序是ADS1.2下的汇编示例程序，对于初学者有很大帮助！-This procedure is compiled under ADS1.2 sample procedures are very helpful for beginners!

ylp2410的bootloader源码，支持串口和usb下载映象文件，经过测试的，很好用-ylp2410 the bootloader source, support serial and usb download image files, tested, very good use