利用程序实现ADC_TLC549采样

Altera官方FPGA电机控制的中文文档，很不错的参考资料(Altera Official FPGA Motor Control Chinese Document, Good Reference)

Rst是低电平有效的系统复位信号，Clk是时钟信号。AB[5：0]是地址信号，DB[7：0]是数据信号，wr是低电平有效的写信号。start是启动信号。 模块中有一个64x8的双端口的存储器。系统复位结束后，可以通过AB、DB和wr信号向同步存储器写入数据。当写入64个数据后，给出一个Clk周期宽度的脉冲信号start，则系统从存储器0地址处开始读出数据，读出的8位数据从低位开始以3位为一组，每个时钟周期输出一组，即第一个时钟周期输出[2：0]位，第二个时钟周期输出[5：3]位，第三个周期输出1地址的[0]位和0地址的[7：6]位，直至将存储器中64x8数据全部输出。若最后一组不足三位，则高位补0。 (Rst is an active-low system reset signal, Clk is a clock signal. AB [5: 0] is the address signal, DB [7: 0] is the data signal, wr write signal is active low. start is the start signal. Module in a dual port memory of 64x8. After the reset, you can write data to the synchronous memory by AB, DB and wr signals. When data is written to 64, given the width of a pulse signal Clk cycle start, the system begins to read the memory address 0, 8 data read out a low starting with three as a group, each clock outputs a set period, which is the first clock cycle of the output [2: 0] bits, the second clock cycle output [5: 3] position, the third cycle of the output of an address [0] and 0 address [7 : 6] bit, until all the data in memory 64x8 output. If the last group of less than three, the high 0s.)

数字时钟，包括流程图以及编码和完整的实验报告，内容详细丰富。(Digital clock, including flowcharts, and coding and a full lab report, detailed and rich.)

通信中加扰/解扰算法。FPGA源代码，verilogHDL语言实现，包含测试程序。(Perturbation/perturbation algorithm. FPGA source code, verilogHDL language implementation, including test procedures.)

It s Flicker_LED code.Verilog for MaxV.

我重视基本的向上和向下计数器。这不是基本up_down counter.this编码方法不同有关。

哈希算法FPGA实现代码，采用MD5算法，并给出了仿真波形。(MD5 hashing algorithm for FPGA implementation code)

复制去Google翻译翻译结果

Design FPGA in Labview

FPGA实现增量式光栅尺正交脉冲解码，基于Verilog(FPGA realization of incremental grating ruler orthogonal pulse decoding, based on Verilog)