On the eye to achieve a few procedures, mainly used for electronic communication...

MSP430与DS1820接口程序，实现数据操作等

用于两单片机利用串口通信。有完整的原理图、仿真、程序。-For the use of two single-chip serial communication. A complete schematic, simulation, process.

ext实用的俩种布局 好看大方，项目中完全可以拿过来直接用-ext auto Container Control!

80C51单片机中字符型液晶1602显示实验的源程序，里面包含了1602的datasheet。-80C51 MCU 1602 character LCD display source experiments, which contains the 1602

IC卡操作软件:AT88SCl604芯片的操作模式有五种。它们是通过配PGM、RST、CLK等引脚信号及内部地址计数器(IAC)的状态组合来实现。 (1) 芯片复位操作： AT88SCl604有两种复位方式:上电复位和控制复位。 上电复位： 上电复位是当芯片加电时的最初状态。上电复位属于芯片 内部复位。它将使芯片内部所有的隐含标志复位到"0"状态。并使地址计数器复位到0位。 控制复位： 当CLK为低时，在RST脚上的一个下降沿将便芯片产生复位操作。 控制复位是将地址计数器复位到0位，而不影响任何内部标志的状态。-IC Card operating software : AT88SCl604 chip mode of operation there are five. They are allocated by PGM, RST, etc. pin CLK signal and the internal address counter (IAC) portfolio of the state is to be achieved. (1) chip reset operation : reduction AT88SCl604 two ways : power-on reset and reset control. Power-on reset : power-on reset when the chip is in power at the initial state. Power-on reset the internal chip is reset. It will enable all internal chip implied signs reset to "0" state. Make address counter reset to 0. Reset control : When the CLK for the low, the RST feet of a falling edge chips will have to reset operation. Reset control is to address counter reset to 0, without prejudice to any signs of internal sta

yong 1602 yejing xian shi db15b20 de wen du ,mcu wei 89s52.-A small system to display temperature.

这是致远电子 MagicARM2410实验箱上基础实验的步进电机编程原代码-This is the electronic MagicARM2410 Jhihyuan me on the basis of experimental trials stepper motor programming source code

gccavr书籍内容包含gcc应用安装及对avr下载说明和电路的配置-gccavr books contain the installation and application of gcc right avr download notes and circuit configuration

LCD T6963驱动程序 LCD T6963驱动程序-LCD Driver T6963 T6963 LCD Driver T6963 LCD Driver

本程序实现74HC165芯片的使用功能，在51单片机上实现-this program is to tell how to use 74hc165 on 51 single chip controlere