Msp430的flash读写文件配置文件，(msp430f427芯片)

用中断的方式控制lcd的显示，单片机仍然是h83664十六位单片机。此程序包含单片机的接口的配置以及各种写lcd的子程，使用中断来控制lcd顺序显示A－Z，当然，可以换成其他的显示内容，由于接口程序已经编好，只需要把要显示的内容改一下就可以实现其他内容的显示-With interruption control lcd display, single-chip is still 16 Singlechip h83664. This procedure includes the configuration of single-chip interface and a variety of writing a sub-lcd-way, the use of interrupt to control the order in lcd display A-Z, of course, can be replaced by other display content, as a result of interface procedures have been developed only to To display the contents of change can be achieved about the display of other content

基于AVR的USB单片机的源代码,其中部分代码被用在产品上.-based on the USB AVR microcontroller source code, part of which code was used in products.

本程序实现了对MOTOROLA08AB32单片机EEPROM的访问，可自动配置波特率，实现了对EEPROM的读、写和擦除操作。-This procedure MOTOROLA08AB32 realize single-chip EEPROM of the visit, can automatically configure the baud rate, to realize the EEPROM read, write and erase operations.

凌阳单片机（SPCE061A）IIC总线驱动程序-Sunplus Singlechip (SPCE061A) IIC bus driver

PT16312驱动程序，现在80%的家电VFD（荧光显示屏）都用它做驱动IC驱动！外部可接24个按键和8个口线。-PT16312 driver, now 80% of the appliance VFD (Fluorescent Display) are using it so driver ICs drive! External access the 24 keys and eight mouth lines.

3字节4字节浮点数转换程序，用来解释单片机的浮点数-3 bytes 4 bytes float switching procedures used to explain SCM float

NE5532+TDA2030 原理图及PCB-NE5532+ TDA2030 Schematic and PCB

采用2051单片机控制的红外解码程序，采用汇编语言实现-2051 MCU control using infrared decoding procedures, using assembly language to achieve

单片机基础，经典,初学必备-microcontroller based, classic, beginner essential

一个AduC845实验板的电路图以及实验源代码-ADuC845 experiment a circuit board, as well as experimental source code