STC51单片机128K sram读写实验的C语言程序，串口调试助手显示。...

CC2430 DMA程序 CC2430 DMA程序 CC2430 DMA程序-CC2430 DMA process procedures CC2430 DMA procedures CC2430 DMA procedures CC2430 DMA

Keil Cx51 V7_0单片机高级语言编程与_uVision2应用实践 徐爱均 彭秀华主编 电子工业出版社-a classic mcu programming book about keil

CAN 程序使用MCP2515 由STM32做主芯片控制-CAN program use MCP2515 the mater chip is STM32

此程序为飞思卡尔智能车校内选拔赛主控为STC51单片机的初始程序-This is a smart car in schools Freescale trials STC51 SCM control for the initial procedure

本程序为某企业的税控机固件程序.基于东芝TMP93CS41 16位单片机编写,符合国家标准.该程序已经经过多次长期调试.-the procedures for a business tax control machines firmware procedures. Based on Toshiba TMP93CS41 16 MCU development, in line with the national standard. The program has after many long debugging.

测试温湿度以及烟感报警,硬件采用长应8000系列-Test temperature and humidity as well as the Smoke Alarm, hardware should be used long-8000 Series

firmware 3.3.4.8 for int6000 powerline

L298N控制步进电机正反转程序，单片机采用凌阳SPCE061A，连接方式请按程序注释连接，工程可下载直接使用。-L298N positive procedural step motor control, microcontroller using Sunplus SPCE061A, connection, please connect the Notes in accordance with the procedure, the project can be downloaded directly used.

can总线c语言 canopen 源程序-canbus canopen source program

本程序为LCM128X64的驱动程序，控制器为KS0108，即有汉字驱动程序，又有图形驱动程序。-This procedure for LCM128X64 driver, controller KS0108, which has Chinese characters drivers, and graphics drivers.