VERILOG串口接收程序

嵌入式linux下关于mtd层源代码分析-Embedded linux on the MTD layer under the source code analysis

Michael J. Pont 的嵌入式系统编程讲座1， 8051CPU，keil开发环境。英文的，通俗易懂。-Michael J. Pont Embedded Systems Programming Lecture 1,8051 CPU, keil development environment. English, user-friendly.

uclinux下压缩库文件-Basis under compression library

用SL811USB接口芯片读写U盘FAT16固化程序(C51源代码)-SL811USB interface chip with read and write FAT16 U disk firmware (C51 source code)

关于nxp的主控芯片的所有关于USB的主机、从机、接鼠标、键盘 、自制HID等的源代码。各种USB底层应用驱动

The objective is to set up SPI communication between VTI Technologies digital pressure sensor component and an MCU of an application device ATMEGA16L. In this code example: ?The MCU is configured ?SCP1000-D01 is initialized and configured ?The high resolution measurement mode is activated ?Temperature and pressure information is read always when the DRDY pin is in high state Please refer to the document "SCP1000 Product Family Specification 8260800" for further information on SCP1000 register addressing and SPI communication. This document applies to the SCP1000-D01.-The objective is to set up SPI communication between VTI Technologies digital pressure sensor component and an MCU of an application device ATMEGA16L. In this code example: ?The MCU is configured ?SCP1000-D01 is initialized and configured ?The high resolution measurement mode is activated ?Temperature and pressure information is read always when the DRDY pin is in high state Please refer to the

libupnp的源码，基于C编写，实现了tv的demo例程，最新版本，DLNA的协议正是基于libupnp协议实现的

在机器人中常用的伺服电机工程可变占空比。该代码提供在三个不同的角度的工序明智旋转（0 - 45 - 90度）。不直接连接伺服销到控制器。使用NPN晶体管控制引脚。

44B0modbus_ascii程序要的-44B0modbus_ascii procedures to the

本文章是高质量C++C编程指南，让学习者更上一层楼-This article is a high-quality C++ C Programming Guide, so that a higher level learners