vhjhkjhjkj，mnbjk

at24c01和02是串行存储器的经典，学会并应用它对与工业或者学习都有极大的帮助。因此我在此上传它的原理图及其程序。-at24c01 and 02 is a classic serial memory, learn and apply it to industrial or study has a great help. Therefore, I would upload its schematic diagram and its procedures.

WM-02U读卡器VBDEMO,非常好用哦

非接触式IC卡程序样例2-non-contact IC card Example 2

430读写IIC总线以及中断控制程序-430 literacy IIC bus and interrupt control procedures

nR24L01_EVB开发板试验接口初始化及模块读写程序-nR24L01_EVB development board initialization and test interface module to read and write procedures

用C8051F330单片机控制L297和L298驱动步进电机。能够实现正反转-C8051F330 SCM with L297 and L298 stepper motor drive. To achieve positive

CAN的调试程序。CAN的初始化重要包括下面几个方面。RXB0SIDH，RXB0SIDL，RXB0MIDH，RXB0MIDL。这是接收过滤器。TXB0SIDH，TXB0SIDL，TXB0DLC，这是发送标志位。还有波特率寄存器。操作模式为 正常模式。-CAN debugging procedures. CAN initialization important aspects include the following. RXB0SIDH, RXB0SIDL, RXB0MIDH, RXB0MIDL. This is the receiver filters. TXB0SIDH, TXB0SIDL, TXB0DLC, it is sending signs spaces. There baud rate register. The normal mode of operation for the model.

用于对TLC5615数模转换芯片进行控制，把接收到的数字信息，送到5615从而恢复模拟信号！-for several TLC5615 right-analog converter control, and receive digital information, which was sent to 5615 so as to restore analog signal!

AT89S51单片机　输出Pulse Width Modulation　Wave -AT89S51 MCU Output Pulse Width Modulation Wave

利用STC单片机实现软件模拟全双工串口的程序，只用一个定时器，消耗系统资源很少。-using SCM software simulation of the full-duplex serial procedures, only a timer, depletion of scarce resources system.