采用2051单片机控制的红外解码程序，采用汇编语言实现

7290i2c软件包.rar可以实现多种功能的I2c

MSP430系列单片机的I2C源程序。可用于对I2C的学习和研究-MSP430 series MCU I2C source. I2C can be used to study and research

FM1702芯片开发板源码采用AT89C52单片机控制射频芯片1702可以用在水表电表等上面-FM1702 chip development board source control using AT89C52 1702 RF chip can use the meter to a meter above etc.

TCP/IP for mcu8051

单片机P1口与4个按键连接，用于信号幅度和频率调节操作键。单片机P0、P2.7、P3.6(-WR)与DA0832、2个741(运放)连接构成波形信号输出电路。 编程使波形信号输出电路输出正弦波信号，并且可通过操作键调节信号的幅度和频率。幅度和频率调节级别从0~10，共11个等级。 -Singlechip P1 I connect with the four buttons for the signal amplitude and frequency adjustment operation keys. Singlechip P0, P2.7, P3.6 (-WR) and DA0832, 2 months 741 (operational amplifier) to connect constitute waveform signal output circuit. Programming so that waveform signal output circuit output sine wave signal, and can be operated keys adjust the signal amplitude and frequency. Amplitude and frequency adjustment level from 0 ~ 10, a total of 11 grades.

DS1302实时实钟avr单片机控制程序-DS1302 real-time clock control procedures avr Singlechip

/* 程序详细功能介绍： *当按下按键P3.3 ，AT89S51单片机产生“叮咚”声从P3.2端口输出 *程序设计方法 * 1． 我们用单片机实定时/计数器T0来产生700HZ和500HZ的频率，根据定时/计数器T0，我们取定时250us， * 因此，700HZ的频率要经过3次250us的定时，而500HZ的频率要经过4次250us的定时。 * 2． 在设计过程，只有当按下SP1之后，才启动T0开始工作，当T0工作完毕，回到最初状态。 * 3． “叮”和“咚”声音各占用0.5秒，因此定时/计数器T0要完成0.5秒的定时，对于以250us为基准定时2000次才可以。 */-/* Procedure detailed functional Introduction:* When pressing the button P3.3, AT89S51 Singlechip a

使用单片机C8050F330对无线发射接受模块进行配置与控制,使组件成为一个无线通讯中的基站.-The use of single-chip wireless C8050F330 launch module configured to receive and control, so that components into a wireless communications base station.

H4100射频卡驱动程序，该程序应用久经考验-H4100 RF card driver, the application of tried and tested procedures

单片机显示子程序初始化 C语言编程 保证好用-Single-chip display initialization subroutine to ensure that use C language programming