Proteus simulation example, in the Proteus simulation under the uart, very good,...

实现STC89LE516AD单片机的A/D转换功能，时钟11.0592M，转换结果以16进制输出到串行口，可用串行口调试程序并观察输出结果，注解非常详细。-Achieve STC89LE516AD MCU A/D conversion clock 11.0592M, conversion results to 16 hexadecimal output to the serial port, serial port can be used to debug programs and observe the output, very detailed comments.

外国人开发的单片机网络资料，包含原理图，PCB图，调试程序，就是语言比较难懂，给大家看看作为参考吧-foreigners development of the single-chip microcomputer network information, including drawings, PCB plans, debugging procedures, Language is more difficult, for everyone to look at it as a reference

基于avr,D12的U盘设计,有完整的USB1.1的协议代码.-Based on the avr, D12 U-disk design, have complete agreement USB1.1 code.

c8051f系列HEX例程，几乎是全系列的-HEX Series c8051f routine, almost full range of

视觉暂留，编程从一个I/O口输出一扫频信号，驱动一支LED灯闪动，频率范围为10HZ~99HZ，扫描时间为30秒，在LED闪动期间观察，一旦发现无法识别LED灯闪动时，按下按键K1，立即停止输出，并将此时的信号频率显示在数码管上，该信号的周期为测试者的视觉暂留时间。-Persistence of vision, programming from an I/O port outputs a sweep signal to drive an LED light flashing, the frequency range of 10HZ ~ 99HZ, scan time of 30 seconds, the LED flashing during the observation, once found it impossible to identify the LED lights flashing, press the key K1, immediate cessation of the output, and at this time the signal frequency displayed on the digital control on the test cycle of the signal" s persistence of vision time.

实现I2C终线的功能，24C64的I2C的总工会系啊-I2C to achieve the function of the end line, 24C64, Department of Trade Unions of the I2C ah

P89CXX编程器控制CPU接收和控制程序-P89CXX programming control CPU to receive and control procedures

8位串行LED测试程序，带有字库文件，C51语言，KEIL uvision2下编译通过，并硬件调试通过-eight serial LED testing procedures, with character, C51, uvision2 under KEIL compiler, and hardware debugging through

1302时钟芯片的pic程序，完全可以应用在其他的单片机上（不过好像如果速度太快的要改一下）-1302 clock chip pic procedures can be applied to other MCU (But if the pace seems too fast to change it)

金鹏 LCD AVR 128 驱动程序 已经调试成功显示 -Jinpeng LCD AVR 128 Driver