NS2的一些学习资料，是我在各种网站广泛收集…

本人在测试与仪表通讯时写的简单的串口接受程序，对初学者有很大帮助-I tested with the instrument of communication when writing simple serial port to accept the procedures are very helpful for beginners

This module can be used to interface to the MMC card in MMC or * SPI modes. It supports a multiple card environment. The reset and * identification processes assume multiple cards on the bus. * In MMC mode, the card number is used as the RCA operand in the * commands.

可自行转换成源代码 (1) 推导出单径瑞利信道中的BPSK相干解调的理论误码率性能，并画出比特信噪比与误码率的关系曲线。 (2) 在单径瑞利信道中，请设计一种时分的导引辅助的信道估计方法，用Simulink进行仿真，测量BPSK的误码率性能，画出比特信噪比与误码率的关系曲线，并与理论误码率曲线进行对比。

锁相环程序，用MATLAB 编写，用来防真琐相环的工作过程。有学习价值-A PLL S PROGRAM CODING IN MATLAB,WHICH CAN SIMULATE THE PROCESS OF PLL.IT S VALUABE FOR LEARNING

ofdma 系统中的各种资源分配算法仿真-OFDMA system, the various resource allocation algorithm simulation

DNP3 Object Library Documentation (*.doc extension) 2.1 GENERAL This section describes the basic rules for the declaration of information elements. These rules have been derived from the IEC TC57 870 series of standards or drafts. These rules provide an unambiguous means of describing and representing data irrespective of its origin. Device profile documents are used to indicate the exact origin and meaning of the data object for each telecontrol device.

最佳升余弦滚降系统的多径传输. 滚降系数0.5, 取样时间无偏差.-best Raised Cosine system multipath transmission. Roll-off coefficient of 0.5, sampling time without deviation.

Moto720 DemoCode

标准C实现在SCO UNIX下通信-achieve the standard C SCO UNIX communications

目录邮件发送高级编程是一个高级的邮件发动程序，能够设定smtp的验证，同时也能够发送附件，还能够设定各种编码以及数据加密。 -Advanced Programming is a senior mail launch procedures to set smtp test also sent to the annex, but also can set all kinds of coding and data encryption.