with a series of RS coding procedures, using BERLEKAMP

关于3G基站的培训，现在正在搞TD，应该对大家有用处。-3G base stations on the training, are now engaged in TD, everyone should have usefulness.

单音信号的一些频率估计程序，最大似然方法,Pisarenko法等。-This site presents some Matlab (tm) code for estimation of the frequency of a single, constant tone in noise. While these methods may be extended to the multiharmonic and multi-tone cases, these programs do not include this extension.

通过操作com口，收发短信。支持发送wap push-Through the operation of com port, send and receive message. Send wap push support

这是一个偷在后台可以用flash把所有的信息传到电脑里。如果你用flash卡住了，所有的东区居民都已经悄悄离开了。开源可以热键呼出。

卷积编码、维特比译码的MATLAB代码，程序来自《现代通信系统－使用matlab》英文版，个人用着不错：）-convolutional codes, Viterbi decoding MATLAB code, procedures from the "modern communication systems-using Matlab" in English, with a good personal :)

0. Install the rp-pppoe-software -------------------------------- You should have already done this by the time you re reading this. If not, go back and read README. 1. Set up your Ethernet hardware -------------------------------- First, make sure the Ethernet card you intend to use with the modem is visible to the Linux kernel. Just how to do this is beyond the scope of this document. However, if the card is the only Ethernet card in the system, executing: ifconfig eth0 should display something like this: eth0 Link encap:Ethernet HWaddr 00:60:67:62:31:D4 plust some more lines. Your HWaddr will be different. As long as you see the HWaddr line, your card should be working. DO NOT assign an IP address to the Ethernet card. DO NOT configure the card to come up at boot time.-0. Install the rp- PPPOE-software-------------------------------- You should have al ready done this by the time you re reading this. I f not, go back and rea

Transporting DNP V3.00 over Local and Wide Area Network. 1 Overview 1.1 Purpose DNP V3.00 (hereafter referred to simply as DNP) was designed for serial point-to-point communication (e.g. RS-232) with limited support for half duplex serial networks (e.g. RS-485). In order for devices to exchange DNP messages in a local (LAN) and/or wide area network (WAN), one must either augment the protocol to support a network environment or use an existing network transport mechanism. This document takes the latter approach specifically, to define how to transport DNP traffic on the internet protocol suite. -Transporting DNP V3.00 over Local and Wide Area Network. 1 Overview 1.1 Purpose DNP V3.00 (hereafter referred to simply as DNP) was designed for serial point-to-point communication (e.g. RS-232) with limited support for half duplex serial networks (e.g. RS-485). In order for devices to exchange DNP messages in a local (LAN) and/or wide area network (WAN), one must either aug

3G移动通信UMTS PCCard短信监控-3G mobile communication UMTS PCCard message monitoring

UWB的BPSK与PPM调制程序,用于超宽带中的BPSK调制与PPM调制的仿真与实现。-UWB modulation of BPSK and PPM procedures for ultra-wideband of BPSK modulation and PPM modulation simulation and realize.

基于BlueSleil的Sample 查找附近的蓝牙设备 确定安装了蓝牙和BlueSleil-BlueSleil based on the search for near Sample Bluetooth equipment installed to determine Bluetooth and B lueSleil