rtlinux3.0 的源代码

这个例子描述了如何配置和使用GPIOs通过STM32F1xxHAL_API。PD.07, PD.13, PD.03 and PD.04 IOs (configured in output pushpull mode)toggle in a forever loop.On STM3210C-EVAL RevC board these IOs are connected to LED1, LED2, LED3 and LED4.非常适合使用STM32做跨平台编程。对初学STM32的开发人员了解GPIO的配置很有帮助。

linux下的nandflash驱动程序,这是从国外网站上下载来的-nandflash the driver, which is from overseas sites to download

PICC学习，对初学PICC者可提供大大的帮助。-PICC learning, beginner PICC for those who can provide a significant help.

凌阳单片机硬件说明书，详细介绍了凌阳单片机的硬件结构。-Sunplus Single-chip hardware specification, detailing Sunplus MCU hardware structure.

让蜂鸣器唱歌的程序,利用从音乐中提取出的文件资料,控制发音长短来实现-Let buzzer to sing procedures, the use of music extracted from the documents, control the length of pronunciation to achieve

USBTEST USBTEST USBTEST-USBTEST USBTEST USBTEST USBTEST

MSP430F449与ATT7022开发的一款三相表demo，完善中，其中的几个程序模块，仅供参考。-MSP430F449 with the ATT7022 the development of a three-phase table demo, perfect, where several program modules for reference purposes only.

Bootloader和ucosII simuCPU模拟器在移植过程中的具体源代码

与stk相关的avr bootloader程序,采用avr-gcc编写.-associated with STK avr Bootloader procedures used avr- gcc prepared.

at91sam7s63,ads1.2编译器 本程序为为一个简单的跑马灯演示： 1，完成基本的初始化 2，驱动板上的四个发光二极管(DS1,DS2,DS3,DS4) 3，驱动板上的四个按键(PB1,PB2,PB3,PB4) 4，现象为四个发光二极管不停的依次闪亮 当有PB1按下,闪亮的速度加快 当有PB3按下,闪亮的速度减慢 -at91sam7s63. ads1.2 compiler for the procedure for a simple demonstration of 5,250 : a complete two basic initialization, the four-panel light-emitting diode (DS1 and DS2, DS3, LST), 3 the four-panel buttons (PB1, PB2, PB3, PB4) 4. phenomenon of four LEDs flashing constantly followed the PB1 When pressed, shiny speed when PB3? shiny slower pace