at91sam7s63,ads1.2编译器 本程序为为一个简单的跑马灯演示： 1，完成基本的初始化 2，驱动板上的四个发光二极管(DS1,DS2,D...

将CAN现场总线移植到UCOS2中的驱动程序，在BC中调试运行成功-CAN fieldbus will be transplanted to UCOS2 the driver, were in BC successful operation Debugging

linux2.4下蓝牙模块例程 包含驱动程序及测试程序-linux2.4 under the Bluetooth module that contains the driver routines and testing procedures

本程序功能是在FPGA上nios处理器的lcd接口程序。-The program features in the FPGA on the Nios processor lcd interface program.

This a Good IDN Client.

DTMF解码，使用格泽尔算法，对数据进行实时采集计算，得到解到的DTMF码子。

mips linux 仿真环境修改补丁！-MIPS simulation environment patches!

tinyos中对cc1000芯片的操作实例，其中，tinyos是无限传感器网络节点的嵌入式操作系统。-tinyos cc1000 chip on the operation of examples, which are unlimited tinyos sensor network nodes embedded operating system.

1， SPI_877A,是针对PROBE877A所写。 SPI_877,是针对PROBE877所写。 SPI_77，是针对PROBE77所写。 初次使用使用PICMATE2004或者其简化版精灵版，如果为以上提到的3款型号，并有TPDEM1， 请根据PROBE型号在相应文件夹下打开项目，编译，并运行，具体连线请看各文件夹说明。 2， 其它文件夹项目均针对PROBE877A所建立，如果要使用PROBE877，请修改头文件，并选择PROBE877支持的芯片。 3， 严格禁止将PROBE877与877A混用，否则将造成仿真芯片工作异常。-1, SPI_877A, is written by PROBE877A. SPI_877, is written by PROBE877. SPI_77, is written by PROBE77. First-time use or its PICMATE2004 Wizard version of Starter Edition, if for the above-mentioned models 3 and TPDEM1, please PROBE models in the corresponding folder to open the project, compile, and run, the specific connection see the folder Note. 2, other projects are folders created for PROBE877A, if you want to use PROBE877, please amend the header file, and select PROBE877 support chips. 3, is strictly prohibited PROBE877 and 877A will be a mix, or else the work will result in simulation chips abnormal.

电动机控制程序 -motor control procedures

应用背景这是一个I2C扩展PCA9698源代码。你可以用2个引脚SDA和SCL 40 GPIO。关键技术