嵌入式串口实例，有部分测试程序，功能：每隔2秒发送“1234567890”，并打印内容。接受也是每2秒一次，并打印内容，出错时打印出错信息...

Oscillator Switching Demonstration for the PIC18CXXX

基于三星公司的32处理器s3c4510的bootloader程序，采用ADS1.2编译，该程序运行后可通过网口采用tftp协议下载应用程序。- Based on the Tristar company s 32 processors s3c4510 bootloader procedure, uses the ADS1.2 translation, after this procedure movement the passable net mouth has used the tftp agreement downloading application procedure.

2440的flash驱动，通过串口接收上位机信息，然后写入flash中,自带flash检测程序-2440 of the flash drive through the PC serial port to receive information, and then written into the flash, the onboard flash detection procedures

为本人开发项目中的一个程序,也是仿照他人的程序改动的,以人共享:arm(44b0)的程序,实现功能如usb,串口等-I development project for a procedure, the procedure is modeled on changes to others to share: arm (44b0) of the procedures, to achieve functions such as usb, serial, etc.

用于控制带有Pololu电压反馈的线性执行器的线性位置和带有Tiensy 3.1 Pololu正交编码器的直流电机的角度位置的代码。

LPC2214的IAP应用编程，这里指通过在应用编程可以升级代码-LPC2214 IAP application programming, in this case through the application programming code can be upgraded

基于LPC2119和uC/OS-II的Modem驱动源代码-based LPC2119 and embedded/OS-II Modem driver source code

基于stm32的小车控制程序，使用的是ov7620摄像头。这是一个完整可以跑的智能车程序。通过设置好GPIO,NVIC,USART,TIMER等等stm32典型的外设去从ov7620获取赛道信息，然后通过模拟处理串口接收回来的数据整合出轨迹从而实现控制。

指纹识别芯片fps200（富士通）在linux下的驱动程序（for arm7(ep7312) linux，其他芯片需要修改映射内存地址）- Fingerprint recognition chip fps200 (Fujitsu) under the linux driver (for arm7 (ep7312) linux, other chips needs to revise mapping memory address)

uCOS移植范例,开发人员或嵌入式爱好者可以借鉴。-uCOS transplantation example, developers or embedded lovers can learn from.