此程序实现了msp430在段位式显示器的显示，也包括一些驱动程序，希望给初学者有所帮助...

MCU与PC键盘通信程序，接口为PS/2；I2C通用驱动程序-MCU with a PC keyboard communication procedures, interface for PS/2; I2C common driver

1总线通信协议应用实例-a bus communication protocol Application

arm7 LPC2136的Keil for arm 工程模板，包含了uCOSII操作系统。对Keil编译环境熟悉的单片机开发人员非常具有参考价值。-arm7 Keil LPC2136 the arm for the project template, uCOSII operating system contains. Keil compiler to the environment familiar microcontroller developers have great reference value.

使用键盘上的上、下、左、右四个按键，可以分别控制led1,2,3,4, 每个LED 对应的Port 请参考“实验平台介绍”说明文档。要求按下 上面提到的四个按键中间的一个按键后，该按键对应的led 被点亮，持续1 秒钟以后led 熄 灭。-Use the keyboard on the upper and lower, left, and right buttons, can control led1, 2,3,4, each LED corresponding to the Port, please refer to " experiment on" documentation. Requirements of the four above-mentioned press the middle button of a button, the button that corresponds to being light led, continuous 1 second later led out.

stc89C51读写AT45DB041的源码，实现了数据手册中的所有命令

通过pid算法来对水温的测量、控制等功能-Pid algorithm adopted to temperature measurement, control and other functions

这是一个用keil-51编写的C51程序，里面含有温度控制的PID核心算法，这为温度的精密控制提供了保证，同时有液晶12864的驱动，而且有PCB电路图，供大家学习和参考。-This is a written with keil-51 C51 program, which contains the core PID temperature control algorithm, which is the precise temperature control can be ensured, while an LCD 12864 driver, but also PCB circuit, for your study and reference.

本设计主要是运用单片机设计一个最小系统――电子时钟，它具有24小时计时功能，能够对时间进行调整，并且能实现时、分、秒的显示，同时还有内设闹钟，时间到时候会响铃，响铃时可以通过按键控制延时再启动或关断。与此同时还设置了整点报时功能；并采用采用了软件去抖的方法扫描键盘，动态刷新显示数码管，并通过查表实现译码输出时间等编程方法；-This design is the use of single-chip design of a minimum system- Electronic clock, it has a 24-hour timer function, capable of time to adjust, and can achieve the hours, minutes and seconds display, but also equipped with alarm clocks, time to When ringing the bell to ring when the button control can delay re-start or shutdown. At the same time also set up the whole point timekeeping function and adopt the use of the software to scan the keyboard shaking method, dynamic refresh display digital tube, and through the realization of decoding look-up table output time programming method

what i s just what we very much need ,jus t give it to you

周立功试验板上的一个程序-weeks meritorious pilot of a board procedures