Motor direct torque control, simulation program, SIMULINK m code

用DSP控制步进电机,DSP选用TMS320C240,-Stepper motor with DSP control, DSP selection TMS320C240,

USB鼠标,单片机的,可以-USB mouse, SCM can be

这是一个用430写ＳＤ卡的原程序大家读读看，好东西哦！-This is an SD card with 430 write everyone read the original procedure, the good stuff Oh!

基于51单片机的 c语言 数字脉搏计的设计-C language based on single chip design of digital pulse meter

MSP430基本编程学习资料 （端口，时钟，定时器，。。。）-Basic learning materials MSP430 Programming

用51写的接收GPS数据的程序，采用中断查寻来接受数据。本程序只接收纬度，经度，时间，.....接收其它数据类似-write with 51 receiving GPS data procedures used to receive interrupted tracing data. This procedure will only receive latitude, longitude, time ...... receiving other similar data

89c51详细介绍-89c51 in detail introduced

IRQ4中断有三个中断源：1KHz、2Kz和4KHz,每一个中断分别控制与IOA0-IOA1,IOA2-IOA3和IOA4-IOA7相连的LED灯-IRQ4 interrupt has three interrupt sources: 1KHz, 2Kz and 4KHz, each interruption of the respective control and IOA0-IOA1, IOA2-IOA3 and IOA4-IOA7 connected LED lights

12864 在51单片机中的程序，用点阵模块改个数组就可以变成自己的了-12864 in MCS-51 in the program, with a change of lattice modules can be turned into its own array of

AT89S51资料，中文版的，很利于大家学习-AT89S51 information, the Chinese version, it is beneficial to them to learn from